r/airbrush • u/chaac92 • 1h ago
General Discussion what i am doing wrong?
i use the airbrush to paint diecast cars (hot wheels mostly) and gunpla, i've been doing it for quite some time and got some nice and bad results, but most the time i have to restart the work once or twice cause i get bad results like grainy finish or some mistake like paint spiting.
my setup is:
Airbrush: Truper Aero 35
needle: 0.3mm
compressor: Pretul 20L (lubricated, but i use a filter for that)
Paint: Ronin Acrylics (Mexican Brand) (i use acrylics cause for hand brush like detailing those work very good, also cause theyre a bit cheaper than solvent based paints)
Thinner: Ronin Acrylics
varnish: Ronin acrylics glossy, Politec water based glossy (local cheap handcrafts brand)
primer: Krylon acrylic primer spray can (no issues with this one, its flawless after it dries)
for as long as i've been doing this hobby i've tried different configurations and paint thinning ratios, no matter what, my airbrush clogs or i get grainy or bad results.
i've tried 2:1 thinner to paint ratio, 1.5:1 even 3:1 to the point the paint i so thin it barely covers anything and it still clogs the airbrush with pressures between 12-25 PSI (yes i've tried a lot of combinations of paint thinnig ratios and PSI).
i use the air-paint-stop paint-air method.
i have tried various distances of spraying, from 2 inches to 5.
worth mentioning i sand with 2500 grit water sandpaper after priming any piece i work with.
at this point i dont know if im just dumb or something in my setup is wrong. i need help with it cause i love doing it but im getting very frustrated cause nothing seems to work.
should i move to solvent based paints? should i change my airbrush? should i quit the hobby?
pictures shows the result i have got,the purple car is varnished with ronin acrylics and its not even glossy, even tho the bottle says it is so i guess i did something wrong (?), the blue truck is only varnished with the cheap handcraft varnish and as you can see i had no major issues with this one it was actually pretty easy to work with it, the last picture (green car) is my most recent work with the ronin acrylics paint, as you can see is pretty "bad" the paint finish, is not smooth and i dont like it, also it feels rough to touch.
any advice is well received.