Hey all, I just finished up my booth a few minutes ago and I'm excited to share.
I had grown to despise pulling out my cheap Princess Auto touch up booth and it being such a pain to ventilate with disappointing airflow. Then it taking up so much space on my desk and being an overall inconvenience. So I set out to make myself something better.
Design Goals:
1: Must be low profile and not take up my whole desk
2: Must be very easy to set up and take down
3: Must not look too ugly
4: Must also service my 3d printer ventilation needs
Design Constraints:
1: I only have one window anywhere in my house that I could reasonably work at and the only possible way I have to ventilate out of it is a 2" tall wooden gap above the in window AC Unit.
2: very limited space in my home to dedicate to this project, and I also rent this home so I can't be too destructive
So to tackle my first constraint, I drilled 5x holes through the small wooden gap and sealed in 5x 1 1/4" pvc electrical pipes. This was the main bottleneck of airflow, as the total area of outlet determined the ideal pipe size. No point running 4" pipe if the outlet is only equivalent to 2"
Then, I modeled up a manifold to transition from the 3" pvc pipe to the 5x 1 1/4" outlets, and 3d printed from PETG.
Afterwards, I needed a way to control airflow to prevent cold drafts into the house, and also to hit my design goal of servicing the 3d printer when printing unhealthy filaments. I didn't like any of the valves I could find online for 3", so I ended up modeling my own Butterfly valve instead. It prints entirely without supports, is a butterfly mechanism, has labeling on the handle to clearly indicate the state of the valve, and separately printed tpu valve seats to help assist with a reasonable level of sealing to somewhat mitigate air leakage and inefficiency.
I have two bilge fans in the system, one upstream of the split in the airline, and one booster up at the spray booth plenum. They are the Hon & Guan 3" bilge fans available on Amazon.
The plenum is about 5 1/2" deep, about as deep as I can go without hitting my knees while sitting at the desk. Deeper is better to equalize airflow.
The opening of the booth is 10" x 16" which is close to the maximum I could reasonably go given a 3" ventilation system. I have used some pegboard and aquarium media as a baffle and filter to help spread the airflow evenly and catch overspray.
The side walls have magnets that serve two purposes, first they snap the sides out to the edge of the opening where I have added magnets into the particle board, and they also hold to each other when folded down to prevent the sides from falling inwards when the booth is closed. They are also 3d printed. Im considering printing again in a transparent petg to assist with visibility in the booth by letting at least some light through.
I also have plans to add in some strip lights, and if I decide a top is necessary to have on the booth I have some ideas on how to accomplish that.
I havent had a chance to do any objective testing of airflow just yet, and havent actually painted with it yet either, but I did do some smoke tests to visually check the airflow and I am very pleased with the results so far. I took some videos, might try to add them in the comments.
Anyways just wanted to share, chat about the project, and answer any questions!
Cheers