Living through ongoing power outages in Gaza means adapting traditional cheesemaking with resilience. Here is how I make our beloved Baladi cheese using available resources:
Ingredients:
1 kg Skim Milk Powder: (I use American skim milk powder simply because it's available here, but you can use any quality milk powder suitable for cheesemaking in your region).
7 Liters Clean Water: For dissolving the milk powder.
1.5 g Rennet: Dissolved in a small cup of water.
6 g Calcium Chloride: Dissolved in a cup of water.
40 g Salt: Sprinkled during the process.
Brine Solution: For preserving and salting the cheese.
Step-by-Step Method:
Dissolving & Heating: Dissolve the milk powder thoroughly in the water. Place the pot over low heat until the temperature reaches around 38°C (100°F).
Adding Calcium: At approximately 30°C, add the dissolved calcium chloride and mix well.
Adding Rennet: Remove the pot from the heat, add the dissolved rennet, and stir gently using only vertical and horizontal lines (avoid circular stirring). Stop as soon as you feel the milk beginning to set/coagulate.
Setting: Cover and let it rest for 30 to 40 minutes (depending on the strength of your rennet).
The Clean Knife Test: Test readiness by inserting a long knife into the curd; if it comes out clean, it's ready.
Cutting the Curd: Cut the set curd into small squares (about 2x2 cm or slightly smaller) using a long knife.
First Salting: Sprinkle salt over the surface of the curds to help draw out the excess whey, then let it rest for about 10 minutes.
Breaking the Curd: Re-cut the curds diagonally in all directions, then gently stir from bottom to top using a long ladle to break them down further. Let it rest for another 10 minutes so the curds release more whey.
Draining Setup: Prepare cheese molds or strainers with small, evenly spaced holes. Place them over a container, ensuring the bottom of the strainer is elevated above the tray surface to allow proper drainage.
Transferring: Using a round strainer, gently transfer the curds from the pot into the molds.
Pressing & Flipping: Smooth the surface, sprinkle a little more salt to help extract water, and let it drain for 4 to 6 hours. Flip the cheese over every hour or so while inside the mold.
Checking Consistency: Press gently with your finger to check if it has reached the desired firm texture.
Cutting: Turn the cheese out of the molds onto a tray and cut it into cubes of your desired size.
Brining: Prepare the brine solution beforehand by dissolving 90 g of salt per 1 liter of boiled and sterilized water. Make sure the brine is completely cool before adding the cheese.
Soaking: Submerge the cheese cubes in the brine solution for 12 to 24 hours.
💡 Storage & Maker's Note:
Serving: Serve fresh with olive oil and local baladi bread! 🫒🥖
Preservation Note: Store in the refrigerator. You can adjust the salt percentage in the brine to your taste. Here in Gaza, because of continuous power cuts, I use a relatively higher salt concentration to act as a natural preservative, helping the cheese last for about 5 days in the winter without spoiling. During the hot summer months, production is paused as it cannot withstand the lack of refrigeration.