r/AskContractors • • 14m ago

RedGuard Uncoupling Membrane Mat Under Shower Pan

1 Upvotes

Hello!

We're renovating our bathroom and after finding water damage from the toilet unknowingly leaking for years we decided to lay RedGuard Uncoupling Membrane Mat on the entire bathroom floor.

Now we're ready to install a Delta Classic 500 Shower Pan Base and have found that the mat is only recommended for installing tile on top and the shower base is recommended to be installed directly on the subfloor.

What are some options since removing the uncoupling membrane mat isn't going to happen now that it's mortared down. We do have to very slightly level the floor under the shower so can we fill the uncoupling membrane divots with mortar to level it out and then lay the shower base?

Thanks!


r/AskContractors • • 20m ago

DIY Window frame modification

Thumbnail
gallery
1 Upvotes

This is a dormer window frame that I'm looking to make wider and shorter. The proposed changes would be to remove the wood in red, add wood where green is, and (not pictured) make a foam-filled 5x3.5 box out of 1x4s to raise where the bottom of the window goes. Any reason why the stud modification wouldn't work? What about my foam box?

The yellow highlighted portion is how small the existing window is. The plan is to put in a casement window for egress requirements. If I'm remembering correctly, the current opening is 31w x 44h and I would be looking at bringing it up to nearly 36w x ~43h.


r/AskContractors • • 1h ago

DIY Bathroom full gut?

0 Upvotes

https://imgur.com/a/O2fInR2

I've got this little bathroom in a carriage house apartment. Updating everything. In order to get the tub insert out, I'm going to have to tear out drywall, aren't I?

I know the answer is yes and I know I'll have to cut the tub insert into pieces to get it out... just wasting 5 minutes on reddit before I get my day going.


r/AskContractors • • 1h ago

“Rip it down” Metricon dual occupancy.

Thumbnail gallery
1 Upvotes

r/AskContractors • • 2h ago

What material is this?

Thumbnail
gallery
2 Upvotes

It is fairly heavy and was in a metal frame used in a residential building as a balcony divider. I assume there are some kind of non combustable requirements so it could be A1 rated but again not sure. I don't have any experience with this. Any help identifying exactly what this is would be much appreciated. Seems like cementboard with a lot of glass like fibres but not sure what brand / type if so.


r/AskContractors • • 9h ago

Is my driveway compromised due to a water main break, flooding, heavy equipment, and freezing temperatures?

Thumbnail
gallery
0 Upvotes

Tl:dr: Crews are installing fiber optic lines in the neighborhood. A water line was damaged, sending a river of water down my street in to my driveway, and over a “concerning” section of driveway that is a future repair, described below. Nightly freezing temperatures, daytime highs in mid 50’s. Today a backhoe was on the concerning spot in the driveway. I’m worried the combination of water, freezing temperatures, and backhoe have damaged my driveway. Location: NW Arkansas.

Full story/details:
Saturday: (Day 1) Morning low temperatures 32f. In the afternoon, workers nicked the water line, and the runoff water intruded the “concerning” spot where concrete drive joins the asphalt street. (Pic 1).

FYI-I was not home at the time so I don’t know how long my driveway was inundated before I arrived home, but it took 60 minutes for water to be fully turned off.

Sunday: (Day 2) overnight temperatures dipped to 34f. Driveway and road dried during the daytime. The water and debris from upstreet washed away the leaves, pebbles and crack “fillers” out of the spot, and loosened small chunks of concrete. (pic 2)

Today (Day 3) temperature low of 27f overnight. I came home to a large backhoe directly on top of the “concerning” spot, digging my curbside easement to reach my water line. (Pic 3)

Upcoming: I expect the crews to tunnel under the driveway to lay the fiber cables as they have already done throughout the neighborhood.

This “concerning” section of driveway has cracks, prior patches, and coarse aggregate showing in spots, with leaves, pebbles and dirt filling the cracks. A bit unsightly for a 45 year old driveway, but in the 2 years I’ve owned, it has appeared solid, no loose chunks. It’s a future repair.

I’m concerned the runoff water, combined with expansion of the ground due to the temps, and the weight of the backhoe have damaged the driveway, and the tunneling under the driveway will only make things worse.

First time homeowner here- Am I overreacting? Are my concerns valid, and if so…what do I need to do, or call?

Thanks in advance.

Edit: Bobcat, not backhoe.


r/AskContractors • • 9h ago

Cost Estimate How legitimate does this driveway quote look?

Post image
0 Upvotes

r/AskContractors • • 10h ago

DIY Advise/Opinions please

Post image
1 Upvotes

Needs some help with finishing of my fence expansion. See original post for explanation. Thanks in advance.


r/AskContractors • • 10h ago

exterior renovation

Thumbnail reddit.com
1 Upvotes

r/AskContractors • • 11h ago

Looking for estimated ballpark cost of repairs post house inspection.

Thumbnail reddit.com
0 Upvotes

r/AskContractors • • 12h ago

Do I need a permit to install new drywalls for two bedrooms?

Thumbnail reddit.com
1 Upvotes

r/AskContractors • • 12h ago

What can we do with this entryway?

Post image
7 Upvotes

Posting this for my sister who is not on Reddit. She had her driveway and entryway redone. The old entryway was angled up to the step. Their contractors laid it flat and left it as pictured. Is this normal? Any recourse?


r/AskContractors • • 13h ago

Other What type of professional do I want for cutting holes in plaster before a whole house Rewire?

0 Upvotes

Currently closing on a house that will need to be rewired day one. I have an electrician, a plaster person to put the walls back together, and a painter… My electrician doesn’t do the cutting himself and once to meet the cutter at the house to mark off holes and go over what he needs. Am I looking for a handyman? General contractor? Plaster specialist? Demolition/remodel Specialist?

Any help would be greatly appreciated. The house is 1925 and plaster


r/AskContractors • • 13h ago

Do I need a permit rmit for installation of a drywall?

Thumbnail reddit.com
1 Upvotes

r/AskContractors • • 14h ago

Repairing vinyl siding

Thumbnail gallery
4 Upvotes

r/AskContractors • • 15h ago

Water leak near waste line

Post image
1 Upvotes

We have rain water leaking into our basement near the wasteline coupling. This is a picture from inside the basement where water is entering. Outside is our back patio? Any ideas how to find/fix leak?


r/AskContractors • • 16h ago

Best way to fix/replace these joists?

Thumbnail gallery
1 Upvotes

Working on fixing a deck as part of other projects to prep our house for sale. Current plan is:

  • Swap deck boards for Trex

  • Mount rail posts correctly (yes...each post is secured by a 4x4 cut in half at the bottom and mounted with only 2 lag bolts 🙃)

  • Replace ballisters

  • Replace front rim joist

  • Add fascia to front/side rims

  • Fix joists that are too far apart (there is technically 1 more than needed if did my math right, 10 vs 9), 12' wide (parallel to house) x 8' deep (from house going outwards)

As you can see, some of them are between 1/4" and 1" short of the front rim.

Am I right in assuming the best way to fix them is just to replace them? (just the short ones). My other thought was to just trim the longer ones down to the shortest, but I'm not sure if that leaves enough overhang to be code-correct (Ohio).

If so, is the easiest route to take a saw and cut just that joist out (via cutting the deck boards left and right of the joist to isolate just it before removal of all boards), and replace it with a new one moved over a bit?

If that's the easiest route, do remove the front rim joist first then cut/isolate/replace the joist? Or cut into the existing front rim, replace, then pull the rest of the front rim to replace?

Thanks. Already spent enough on carpenters over the last few months...trying to at least be somewhat self-sufficient!


r/AskContractors • • 16h ago

Other Bifold door

Thumbnail reddit.com
1 Upvotes

r/AskContractors • • 17h ago

"bouncing" floors in new build house

4 Upvotes

We purchased a new build and moved in in July. Home was built in 2025/2026. We had it professionally inspected. When we sit on any furniture (couch, dining table) - I can feel when someone walks by, the floor bounce travels up through the furninutre. This includes when my 35lb pup jumps on or off the couch. Are new homes expected to have some bounce? I cannot feel bounce when I am walking, only when someone/something walks by.


r/AskContractors • • 17h ago

Siding Patch Job Advice

Thumbnail reddit.com
1 Upvotes

r/AskContractors • • 17h ago

How bad is this and what is the cause?

Thumbnail
gallery
4 Upvotes

Pictures taken of the kitchen counter edge, the kitchen sink is right on the end. Also pictures from under the house - right behind this is the laundry area and then the back of the house. Pics with the joists running longways (left to right) is the view from the back, so the kitchen sink is maybe like 6 ft in. Pic with the joints running front to back is the side of the house, and the area circled is about where I think the sink is.

I live in New Orleans - location is relevant because:

  1. climate — it’s super humid all the time, of course worst in the summer, and

  2. the city is slowly sinking, so some movement/shifting in the house is somewhat unavoidable.

The house is about 90 years old, and you can tell maintenance hasn’t been great in the last decade or 2. I do rent, but I’m cool with the landlords. So consider this advice for them. We moved in at the start of June.

They replaced the roof like 3 weeks ago, at the end of October, which apparently badly needed to be done, and I think the kitchen was especially bad (given the debris that fell in through the stovetop vent during the process). They replaced the AC unit in early July — after there was so much condensation in the kitchen that there were literally small puddles of water forming in the kitchen cabinets. Part of the reason for this was apparently the AC unit (maybe he meant the vents/ducts?) was like right underneath the kitchen, and it being so old, there was a lot of condensation from that. ((I asked if there was weatherproofing on the underside of the house, but didn’t get an answer on that — though I’m guessing no.))

On the other side of this wall is the laundry area, and there was kinda just like, a hole in the wall for a while. After it was covered up is also when the kitchen cabinets started to form puddles. Around the same time they had the edges of the inside of the bottom cabinets sealed with expansion foam.

We’ve had a dehumidifier running in there that would fill up every ~8 hours (50 pint capacity). This is *after* the new AC unit, but still peak summer heat. (Not great for our electric bill, if you can imagine…) We now leave it to run until it gets to 65% humidity, and it’s a lot better now that it’s cooler.

The sink also wasn’t caulked properly (if at all) until a few months ago. Probably some spillage from over the sink edge too. I’m not really worried much about the cabinet wall being out of plumb, but I’m sure it might indicate other issues.

Which of these things do yall think contributed the most to the issue?

What would be your first steps and/or plan of action?

Thank you in advance!!!


r/AskContractors • • 18h ago

Paid a company to level my floor

Thumbnail gallery
1 Upvotes

r/AskContractors • • 18h ago

Looking for recommendations on how to fix this large drain hole, and steps to prep for shower. This was an existing tub area.

Post image
1 Upvotes

r/AskContractors • • 18h ago

Other Flooring Question

1 Upvotes

I purchased my grandparents’ house in June, and unfortunately, it needs quite a bit of work. I've been tackling renovations room by room and have replaced most of the subflooring throughout the house. I originally purchased enough LVP flooring to redo the entire home, along with a plastic vapor barrier to install between the wood subfloor and the flooring. So far, I've completed a few rooms, but I'm running into a frustrating issue: the flooring is separating at the seams pretty badly. I've tried taking it apart and reinstalling it, but the same problem keeps happening.
After doing some research online, I've come across several posts suggesting that a plastic vapor barrier underneath LVP can cause problems, potentially preventing the flooring from locking together properly. I'm trying to figure out the best way to fix this before moving on to the rest of the house. A few questions: Could the plastic vapor barrier be causing the flooring to separate? Would a foam underlayment be a better option? Should I install the LVP directly over the plywood/wood subfloor instead? If I install it directly over the wood subfloor without a vapor barrier, will the flooring still be water-resistant? Could moisture eventually damage the subfloor? I'd really appreciate any advice from anyone who has dealt with something similar either personally or professionally. I'd rather fix the problem now than have to redo all the floors down the road.
Thanks in advance!