r/snapmaker • u/seeingguidecock22 • 2h ago
Troubleshooting Brand new U1 out-of-the-box DOA Toolhead issue - Support told me to tear down the Z-axis? Need help/advice.
Hey everyone,
Just unboxed my Snapmaker U1, and right out of the box during initial setup/calibration, it fails with a Motor Driver Anomaly:
- Error Code: 0003-0522-0000-0011
- Log: TMC 'extruder1' reports error: DRV_STATUS: 001200a0 s2vsb=1(ShortToSupply_B!) olb=1(OpenLoad_B!) cs_actual=18
I ran a full cross-swap diagnostic test to isolate the hardware:
When the physical toolhead module was in Slot 2, the error reported on 'extruder1'.
When I moved that exact same physical toolhead module into Slot 3, the error immediately moved to 'extruder2'.
The dock slots, carriage wiring, and motherboard channels are 100% fine—the fault moves with this single toolhead module (internal short/open circuit on Phase B).
I submitted Ticket #687252 with all error logs and swap test details, but support replied telling me to follow the Z-Motor Replacement Guide and tear down/reconnect the Z-axis motor cable... on a brand new machine, for a toolhead stepper driver error.
I replied to correct the ticket, but I haven't heard back yet. Has anyone else dealt with a DOA toolhead module out of the box or had tier-1 support send irrelevant repair guides? How long did it take to get a replacement toolhead sent out? Anyone tear a down tool head to fix one?
The z axis appears to function fine, I really don't want to tear apart a brand new machine to check the z axis cable at the very bottom. The guide showed a lot of disassembly and my hands are just not up to that right now, plus I don't think the z axis is involved in any way.
Appreciate any advice!



