r/prusa • u/IronInEveryFire • 20h ago
Creality K1C Ignoring Speed Control
I've been fighting an issue off an on with the K1C at my workplace that has suddenly rendered itself unsolvable. When entering my speed controls into Prusa Slicer (right) it seems to produce G Code with the opposite format of Creality (left) in that the F-Parameter is on the opposite end of the line. I would expect Creality is smart enough to parse the parameters from the line in any order, but it seems to buffer them in the order they are received. This has the effect that the rapid travel speeds are used in the print moves, and vice versa. I previously resolved this by setting all of the moves to the desired print speed so I could focus on other tasks.
Recently, with no changes to the firmware, it has suddenly started ignoring the speed commands for specifically infill moves, which it is performing at the maximum printer travel speed of 600 mm/s (eyeball guess) rather the commanded 300 mm/s (right code shows 150 as it is a project with combined infill). It prints wicked fast, but with less than half the infill it is supposed to have.
Is there some setting or G Code substitution I can make to resolve this, or will I need to make a script to reorder all the F-commands to the start of the line?
