System: Used Pax oak frames, Tonstad doors and Sinarp cover sides for our wardrobes in the newly built apartment.
Hallway: opening was approx 3,995 wide and had 61 cm on one side and 53 cm on the other. As Pax builds approx 60 I had to make a fix on the short side using part of a door. To make it coherent I did the same on the other side. I cut of 6,9 cm at the top to have the 236 frames fit, so that I could use the holes and the Ikea brackets for the top plate. As the last frame also needed to be made a bit slimmer due to the space available (8 cm) I had to screw one of the sides with wood screews and slim the door also. I there glued an oak list to the side which I trimmed using a small hand plane. I added som slim frame pieces in the back and on the sides to make sure the frames would not move. The 229,4 cm doors are all hinged on the bottom screw holes to fit with the 230 cm space. I've adjusted them all to max height, so if they ever start to touch the floor I will take them all down and cut off 0,5 cm in the bottom, add an oak list and then reattach them.
Master: here we felt a full wall of 236 frames would be too massive, so 2,5 meters are full frames, and then I adjusted the remaining 3,5 meter to low cabinets using 201 frames and 1 Tonstad door per cupboard. The side frames and top plate is Sinarp from the kitchen range. I moved everything a bit forward from the wall to fit with the 62 cm that Sinarp comes with and to make space for the wiring. I am not completely finished here and there is bad lighting still so sorry for that, but to make it coherent with the hallway I did cut the tops of here too on the 2,5 meter of full frames at the same height and will make some top shelves with the reamining pieces from the 201 frames, and a couple of Tonstad doors. These doors will be opened upwards using Blum AVENTOS HK-S stay flap lift tip-on. The middle part (50 cm) will not be in use due to the "excellent" placement of the fire system. I also need to fasten the knobs for the low frames. Here I've chosen some black rub knobs that goes well with all the other black elements we have on doors etc. All the doors for the lower frames needed one new hing hole so I found a drill head at the correct size and used the cut of part from the door in the hallway as a template. Just needed to adjust it 0,4 cm from the bottom and drill through. Was actually a lot easier than I feared.
Any feedback on the solution? Let me know what you think! It was fun to build and to get it fitted perfectly.
I did a couple of mistakes along the way and I'd actually really appeeciate some ideas on how to fix the wiring opening I made for the tv++. The opening was to be fitted to the Bestå wire cover, but I made it slightly too big so it's not so pretty unfortunately. Any ideas how to cover it up while at the same time have good cable management would be greatly appreciated.