Hello, this is a little project I've been working on lately. It's a 65V input, 5-50V 25A output step down converter that I want to use for a regulated PSU - this will be the pre regulation stage, then I will add a linear (transistor) regulator after it for fine voltage regulation. I'd ideally like even more voltage, but currently I'm using some hybrid capacitors and they aren't available in higher than 80V.
Which gets me to the first question: what's the best way to approach the output caps? My current config is 12x 47uF with 36mOhms ESR each (GYA1K470MCWADNGS), which have more than enough ripple current rating and come out to around 111mV output voltage ripple. I've tried calculating with 4x UCS2E221MHD, but those have significantly higher ESR (presumably, since Nichicon doesn't specify ESR at the 200kHz this converter is running at) - if I input 100mOhms per cap into the equation, the voltage ripple comes out to around 0.875V, which is insane. I guess the main problem is the 10A ripple current from the converter. Now, if I use ceramic caps, then I'd also have to use a huge bank, especially because of the DC bias/capacitance curve, not even mentioning it would cost at least 15-20 times the price of the hybrids.
The use of the hybrid cap bank gets me to the layout: it's far from ideal, but I think it's as good as I can make it with these components. The inductor is rated as having 45.9A saturation current, so it should be enough. The feedback is connected to the 6 pin header, so that I can connect an external regualtion circuit to it. The zener diode on the output (it's a 36V zener) should prevent the output voltage from being unpredictable if anything happens to the external regulation circuit.
Schematic and layout here: https://drive.proton.me/urls/KV5ASAPQ6G#sYs0FYXTC8zI (hope everyone can access this, I don't have an Imgur account and I apparently can't put more than one picture here in the post).
Hopefully I can get away with a 4 layer board while all layer beign 1oz copper - most of the power planes are huge and the main connections are on two or more layers with plenty of vias in between.
I have never done such a high current/high power design, which is the main reason why I'm asking for a review here.
(btw, vias are free, right, right??)