Not too long ago I posted about subpar audio quality on the boxypixel mod kit. I figured out what was causing the worse perceived lowend performance.
The MKII board puts two parts in series with each headphone channel (per the schematic Boxy Pixel sent me):
- C22 / C23: 47 µF DC blocking caps (C22 left, C23 right)
- R5 / R7: 10 Ohm series resistors (R5 left, R7 right)
The cap and headphones form a high pass filter: the lower the headphone impedance, the more bass you lose. With 10 Ohm IEMs (in this case my Softears Volume S) the cutoff is 140 Hz.
I measure the output impedance and the relative deviation from a 1kHz test sound with a 10 Ohm dummy load:
- 100 Hz: 54 to 58 %
- 50 Hz: 31 to 34 %
- Output impedance at 1 kHz: about 13 to 15 Ω
So roughly -10 dB at 50 Hz relative to 1 kHz, on top of about 5 dB less volume overall, around -15 dB at 50 Hz compared to a stock iPod Classic 7G.
To fix it you can bridge C22 and C23 with a short piece of wire (see post picture).
You need to check if any direct current is flowing to your headphones first though: I measured max 2.1 mV at the iPod side of the caps in every state (on, off, BT on, charging). The caps main justification to exist in the first place is to not have any direct current flowing to the headphones. I figured i can live with a maximum of 2.1mV.
Bridging R5/R7 as well gets back the remaining ~5 dB of volume. Don't bridge only R5/R7, that makes the bass worse. [EDIT: I did not bridge these in my build, the output volume is more than fine without doing this]
Do this at your own risk and measure DC on your own unit before plugging in IEMs. This was in no shape or form endorsed by the boxy pixel team, they just sent me schematics of the filtering after I asked about worse perceived audio quality.
The higher the impedance of your headphones the more diminishing the returns of bridging the caps. It was more than worth it for my Volume S in low impendace mode.
Thanks for reading :)