So I'm a student, just one semester, two classes actually, until I have my mechanical engineering degree. Before college I was a service adviser at dealerships and my trusty car has gotten me through college fairly reliably.
Just a few months ago in January I did my right front wheel bearing, I used an OEM wheel bearing and wheel seal and had a local machine shop press it in. Afterwards, all was good. Break ends and I drive 600 miles back to school, tool around all semester and no problems. During finals week I started hearing a clicking noise in the front corner where I had the bearing done during the winter. A week ago I drove back from school to prepare for my internship and after hours on the highway portion of the drive I noticed I was now getting bearing noise from the OTHER side of the car.
So Wednesday I tear the car apart and do the newly loud bearing with an Autozone one and start to investigate the clunk from the front. The only thing I can find from the right side related to the clunk is that there seems to be a little play in the bearing done a few months before...what the heck?
So I get the new Autozone bearing in, put the car back together, and the new bearing is LOUDER than the one I took out, like catastrophically louder to the point where I went 2 houses down, turned around and promptly parked the car.
I now have BOTH front hubs off the car waiting for tomorrow so I can get new bearings put in both. I just dont have the money for this. Neither the money for the bearings nor the money for the machine shop to press the bearings. I'm just at a loss at this point but I have to get it done somehow as I have to leave Friday for my summer internship which is in New Mexico, 21 hours away.
Basically, is there ANYTHING I can do to make sure the new bearings put in wont have problems? I am completely out of time and money and if I continue to have problems with this I'll be late to report to my internship and my CC will be maxed out.
Thanks for listening.
Also, its a 2003 IS300 with 174k on it.