r/JRITSlounge • • Aug 07 '17

Xpost from r/justneckbeardthings All credit goes to u/leavedaspace

Post image
31 Upvotes

r/JRITSlounge • • Aug 18 '16

I diagnosed one wrong, but I don't even feel bad.

30 Upvotes

2004-ish Isuzu FRR. Early common rail. Truck would run fine, then drop three cylinders. Code 0158, short to B+ on something something injector something. Instant limp mode, cut three cylinders off. Those three were on a common B+ leg. There was power at both branches of that leg, the grounds for each of those injectors were good, each injector was good, the wiring harness tested good, the injector harness tested good, even the pass-through in the rocker box tested good. I hate diagnosing it as a bad ECU, but I ran out of stuff to blame. Put in an ecu. It ran for five minutes then dropped three cylinders. Fuck.

Took valve cover off. Poked around with a multimeter. The injector harness on these is laid out on a plastic platform, so even if a wire were to chafe, it won't ground to chassis. Maybe two would get tangled up, somehow, but that would be very easy to spot. However, there was a 1k ohm connection between the ground leg on the harness and chassis. Unscrewing the leads from the injector removed this connection. The rear three cylinders, so far unaffected, had a 1M ohm connection. Weird.

I stared at it for a while. It's like the motor oil is conducting electricity. Actually, something in the motor oil WAS conducting electricity. This poor truck had the snot kicked out of it, and it had very irregular maintenance. It had a recent oil change, and that revealed the layer of carbon sludge adhered to the top of each injector and around all of the wires. Removing the carbon with a copious amount of contact cleaner and some scrubbing also removed the slight electrical connection, and the ECU no longer interpreted this as a fault-worthy event.

The moral of this story: Change your oil before it solidifies.


r/JRITSlounge • • Jul 19 '18

Car forum started pack

Post image
27 Upvotes

r/JRITSlounge • • May 30 '13

specialty bolts

Thumbnail
imgur.com
27 Upvotes

r/JRITSlounge • • Jul 13 '17

JRITS needs its own gift exchange; It would consist of only 10mm sockets

24 Upvotes

Couldn't be simpler. Do it like reddit's own Secret Santa, but you can only give 10mm sockets. No less than 2, no more than 5, and the brand is up to you.

Its the one gift you know every JRITS subscriber needs


r/JRITSlounge • • Aug 08 '21

Got a big raise yesterday, and I just wanna tell someone else in the trade.

22 Upvotes

But my boss was on vacation and doesn't know about it yet lmao. I had to go over him to his boss (technically his boss's boss), who gave the raise without hesitation. Most of the people I know in the industry locally know my boss and I don't want the possibility of ruining his vacation.

If I manage the same number of hours over the next year, it will be almost a $20k raise.

Everyone party w/ me pls. 🎉🥳


r/JRITSlounge • • Apr 09 '17

Ratchets

Thumbnail
imgur.com
21 Upvotes

r/JRITSlounge • • Jul 09 '17

Worst beach ever.

Post image
20 Upvotes

r/JRITSlounge • • Dec 20 '16

Because I'm a mechanic.....

20 Upvotes

I can't (won't) get a new car til my current one dies, but I can't bring yourself to stop adding oil. (Or coolant, or power steering fluid.)  

I've bought and kept a car I don't like, and is an eyesore, because it's mechanically perfect.  

I see something I know needs fixed, but also know it'll last so I ignore it.  

Worrying about my wife's transmission keeps me up at night but IDGAF that her door clicker doesn't work.  

I think people who use WD40 are stuck in the stone age.  

People ask me what a car is worth to sell/buy because I'm a mechanic. I just make up numbers so they'll leave me alone.  

I get irritated when people want me to do major repairs, but take their car to Firestone for brakes because they don't want to bother me.  

I see cars with features I like and start trying to figure out how to build that into my project car I never work on.  

I make my wife have auto zone install her wipers and light bulbs cause that's free labor, but I won't let then touch my shit.


r/JRITSlounge • • Apr 03 '15

Why are mechanics required to provide their own tools? Why doesn't the employer provide this?

20 Upvotes

Noob question. This always bothered me. But if you work at a shop, wouldn't it make sense that the shop provides the tools so that regardless of who works for them, the tools exist to get the work done?

Is this an oddity in the work-world or is it just with the auto-mechanic world? And, to further my stupidity in questioning this, why haven't things progressed to remedy this?

Update: Thanks everyone for your responses, this is very insightful!


r/JRITSlounge • • Dec 02 '13

My cousin bought a car for $200. He knows nothing about cars.

20 Upvotes

1988 Honda Accord LXi, 247,000 miles. The story is that it was driving along just fine, then just died. It was towed to the PO's house, where it sat.

For six years.

So he'd been texting me, and it's pretty clear that he has no clue what I'm talking about. He's 19, his dad doesn't know shit about cars either. Not the first metric tool at their house until earlier this week, when someone finally bought a rack of metric sockets. I decided to jump in. Bought a repair manual and a multimeter and had it shipped to his house. This would give him something to start with. This morning, I threw a bunch of tools in my truck and started driving. They live 150 miles away, so I had to make a day of it.

The car is surprisingly clean, inside and out. He had put in a new battery, plugs, wires, cap, rotor, fuel filter. The fuel pump was coming on (miraculously. It looks like the PO drained the fuel system. Didn't expect that.) While dicking around with it, I pulled one of the plugs. He had put in E3 plugs. I made a groaning noise. Had to explain the difference between gimmick parts and proven NGKs. I left the E3s in there, because there still wasn't spark.

I headed over to the distributor. Took cap off, had him bump the starter. Distributor turned, so probably not the timing belt. Tested the ignition module. Deader than hell. A call to Autozone was no luck, they had to order it and it was $85. Shit. I really want to see this thing run. Got on craigslist. No luck. Hmmmm...

Went to Autozone. Bought a 4 prong HEI module (82 Chevy C-10) and some wire. Googled "HEI module wiring schematic." I'd taken the distributor off of the engine at this point, so it was easy enough to stick wires into various places and twist them to the HEI module connectors. With the ignition on, you could spin the distributor by hand, hear the fuel pump kick on, hear injectors click, but no spark. The coil was making clicking noises. That's when I saw the crack in the insulation. Checked resistance, the secondary winding was shorted. I'm guessing that's what took out the original ignition module.

I introduced him to paypal and rockauto.com. He's got a checking account but no credit or debit cards, so this way he can order stuff from rockauto without having to pay retail at autozone. Anyway, I showed him what he had to do to put it back together, and what to expect when he got it started. The next step is to somehow get it through state inspection and then magic it to my house without the tires from 2002 blowing out. I can get 'em at wholesale price, and he's working retail somewhere, so every little bit helps. It'll be coming here for timing belt/oil seals/water pump/etc.

At the very least, he can probably get close to a grand for it if it at least runs.


r/JRITSlounge • • May 14 '18

This started a lively debate earlier today amongst my coworkers.

Post image
19 Upvotes

r/JRITSlounge • • Jan 09 '14

This happened to me a few years back, r/justrolledintotheshop thought you guys might enjoy it.

Post image
19 Upvotes

r/JRITSlounge • • Sep 14 '22

Me: Hey mom, can we have tool truck tools? - Mom: We have tool truck tools at home. - The tools at home:

Post image
18 Upvotes

r/JRITSlounge • • Oct 27 '17

The things you find when digging around an old mechanic’s basement.

Post image
18 Upvotes

r/JRITSlounge • • Dec 18 '13

I just traded an '89 Tercel for this thing. I can detect your jealousy from here.

Post image
18 Upvotes

r/JRITSlounge • • Apr 24 '17

Safety squints, engage...

Post image
17 Upvotes

r/JRITSlounge • • Nov 14 '14

FNG (F***ing New Guy) Stories?

17 Upvotes

I know you've got em, lets hear em!

My shop recently hired a guy, a little older than me (I'm 24), on paper looked like a good fit, eagle scout, decent amount of experience, Wyotech grad... but the foreman and I are beginning to have some doubts:

05 Accord Hybrid comes in, horrendous knocking noise from the engine, sounds like it's got no oil at all. Wyotech (WT from here on out) gets the diagnosis. Spends half an hour staring down a scan tool and revving the shit out of this poor car that sounds like it's got no oil in it to no avail other than writing down some codes (Never even opened the hood) that he proceeds to chase around alldata for another 15 minutes before deciding it needs an oil flush, valve adjustment and a cam sensor... Foreman is asked to confirm since WT is new and it doesn't seem right to the writer, in a whole 5 minutes figures out that the timing belt tensioner has failed entirely and the noise is the belt slapping around and the tensioner pummeling itself. How this car didn't jump time with him wringing its neck I do not know as there was zero tension on the belt when I tore it down to replace.

Today he outdid himself though. Foreman is out fishing with the owner and left me in charge, so now I'm doing my job getting shit done and his overseeing/helping other techs. WT is tasked with replacing the trans in a late 90's F150 4x4, I was an R&R guy in a trans shop so I've done a couple of these and give him some pointers on the fastest way to go about it, which he completely disregards and does everything the hardest/slowest way possible turning a 1 hour transmission removal into an all day shit show of broken bolts and cut exhaust that didn't need to happen. Then 5-6 odd hours into this, he finally is ready to drop the trans out and I'm standing on the other end of the bay showing a service writer a few things that he wasn't clear on on a car I had checked out when I see him pull the trans back accompanied by a wonderful waterfall of ATF. I ran over and tossed a pan under it to try and minimize the mess and figure out WTF happened... He'd left the converter bolted to the flex plate ON PURPOSE. When I asked why all he could muster was "Well everyone has their way of doing things, this way's mine" That was the point at which my eye started to twitch and I had to walk away. He didn't say much the rest of the day since everyone else in the shop walked through the area and commented on his mess and pretty much laughed him out the door after they found out how it happened.


r/JRITSlounge • • Oct 26 '13

As someone who rebuilds transmissions for a living, and also avid gamer, funny to see one of the early Batmobiles used a Ford tranny!

Post image
17 Upvotes

r/JRITSlounge • • Aug 25 '17

Why 2,000 Chicago Mechanics Are At War With Car Dealers(AKA why Flat Rate sucks)

Thumbnail
jalopnik.com
16 Upvotes

r/JRITSlounge • • Dec 19 '15

Excellent, now people behind me will know about my mechanical skills.

Thumbnail
imgur.com
16 Upvotes

r/JRITSlounge • • Dec 14 '15

When you nope the fuck out

16 Upvotes

So I'm a flat rate tech who works open to close 7:30-6 six days a week and. Get a day off every other week of my choosing. I normally take days off that were slow when I get there. So I show up to work haul off the scrap metal, btw it's $2.50 a hundred, fuck that, so on my way back after dropping off 2200lbs $63 in my pocket it starts to rain. I walk in the shop only to find a customer has just parked their car in my bay because they didn't want to walk in the rain. Right after that another dipshit customer tried to park their car in the bay next to mine for the same reason. What are you fuckers the wicked witch of the west? You're not going to melt fuck off. I promptly decided today was my day off and noped the fuck out.


r/JRITSlounge • • May 28 '13

Part of being a Jaguar owner is when you have to wait for the tow truck

Thumbnail
imgur.com
16 Upvotes

r/JRITSlounge • • Jun 06 '20

Dropped off a snack for our favorite parts store.

Post image
15 Upvotes

r/JRITSlounge • • Sep 16 '16

Chevy beats Toyota in this morning's key throw event!

Thumbnail
imgur.com
15 Upvotes