I’m trying to get my dad’s 1986 Yamaha XT250 running after it spent approximately 25 years in indoor storage. It was ridden for a few months in the late 90s before being put away.
Carburetor work:
Replaced float and float pin (KEDO).
Replaced pilot screw assembly (KEDO).
Replaced needle valve and seat (KEDO).
Replaced air-cut valve diaphragm (OEM, P/N 5Y1-1490A-00).
Replaced all O-rings and gaskets (OEM).
Replaced all hoses connecting the two carb bodies.
Replaced the main jet on the secondary carb.
Both carb bodies have been completely disassembled, ultrasonically cleaned and thoroughly flushed with carb cleaner.
The only original carb components remaining are the primary main jet and its emulsion tube (which is visibly bent, one of the many gifts left by the previous owner), the pilot jet, and the secondary CV diaphragm (no visible cracks, although it may be slightly stretched).
Float level is within spec, and the pilot screw is 2.5 turns out.
Other checks:
Intake boots are relatively new and still flexible, with no visible cracks.
Spark plug: NGK D8EA, 0.65 mm gap.
Spark plug cap resistance: 9.4 kΩ (rated 10 kΩ).
Visible blue spark.
Valve clearances: Both intake lobes at 0.08 and exhaust at 0.14 & 0.15 mm. Also, the little timing punch marks on the camshaft also line up with the engine in TDC
Me & my dad got it to start last weekend, after a shit ton of kicks. The idle was high (probably need to adjust the idle set screw) and there was quite a lot of white smoke coming out of the exhaust.
We've been unable to get it started again since last weekend, you just kick it and kick it and kick it and it almost catches and/or the kickstarter kicks your foot back like a mule...
Was thinking of ordering a new pilot jet but I thought before I threw more money at the problem I'd get a second opinion... any recommendations are welcome!
P.S. Some unrelated work I have done on the bike:
Replaced a broken decompression shaft
Fixed the threads on the crankcase cover on the clutch side that hold down the oil filter cap (the threads were completely destroyed and all of the bolts that held the cover onto the crankcase were completely stripped :) had to replace every single one of them.