r/FellowProducts • u/Worried-Act-7299 • 1h ago
Espresso Series 1 New Series 1: ~1 bar on every profile, thin hot water, steam never starts. Anyone seen this?
Hi all! I got an Espresso Series 1 as a gift this week (US 120V model, black, firmware 2.5.15), and it has behaved like this since the very first use:
1. No pressure on any profile
The gauge sits at ~1 bar for the whole shot, and the phase shows "INFUSION" the entire time.
Same result on every profile I've tried, both Fellow's and others.
Even with a pour-over grind, the shot runs ~50 s with only thin drips, and the machine tells me to grind coarser because the shot was too long.
2. Hot water spout: only a thin, pencil-like stream.
3. Steam: pressing the steam button makes the pump pulse roughly once per second, but no steam comes out of the wand. A short purge does happen when I put the wand back in the home position.
Setup: 131V outlet on a 20A circuit (plug adapter, since I'm outside the US).
What I've tried so far:
Several profiles
Grind sizes from espresso-fine to pour-over coarse
My guess is that all three symptoms come from the same thing: low water delivery from the pump or inlet (air lock? stuck tank valve?), not grind or profile settings.
Questions:
Has anyone had this on a new unit? What fixed it?
Is there a priming routine that worked for you after an air lock?
What pressure should a backflush-disc (blind) test show on a healthy unit?
Roughly how many grams does a normal unit dispense in 10 s from the grouphead (no portafilter) and from the hot water spout?
Did System Calibration (Settings > Setup) on 2.5.15 change anything for you?
I already have a call scheduled with Fellow support, but I'd love to hear from other owners first. Thanks!
