r/E30 • • Jul 27 '16

We have an FAQ! Help populate it

106 Upvotes

We have the same 3 topics every day and it's cluttering the sub. "What do you think of this E30" and "What do I look for in an E30" are the ones I'm going to start deleting (soon).

We do have an FAQ with the absolute basics. If that. So help us out by suggesting or even writing the content that goes into it.


r/E30 • • 13h ago

my BRG daily during the daytime

Thumbnail
gallery
105 Upvotes

this sub has only seen the build at night so heres some during the day, loved brg on the e36 growing up so i put it on the e30

missing front valence i know lol


r/E30 • • 7h ago

M42 head pitting

Post image
6 Upvotes

There’s a decent amount of pitting on the mating surface for the profile gasket that seals a coolant passage, is there a way to repair?


r/E30 • • 17h ago

Because of my unexpected snow driving. I had to wash the salt of the car today

Post image
34 Upvotes

r/E30 • • 1d ago

At Costco rn

Post image
128 Upvotes

r/E30 • • 1d ago

Picture/Video Had to show off my daily, ignore the bondo

Thumbnail
gallery
123 Upvotes

And yes, I love the Taifuns


r/E30 • • 1d ago

Sunday Guns Out

Post image
56 Upvotes

r/E30 • • 13h ago

Bad idle

1 Upvotes

So I recently posted about my crank no start 87 vert,
Turns out the original seller swapped the engine with a 89 but the fuel lines were swapped. Once I swapped then the car started to run and there was white smoke (first start in 14 Years) but I couldn’t step on the Accelerator. I accepted my win and gave it a break for the weekend. Now I went to turn it on and it sounds horrible😭 it will turn over but it will have a really rough idle and then sputter and die.

It was shooting some black smoke but it wasn’t thick. And it would die quickly. I’ve cleaned the icv, checked and replaced the TPS, and I’m kinda at a stand still right now. Would love any advice or ideas! I’m trying to keep the engine so anything that would help me use the engine would be nice!


r/E30 • • 1d ago

Info needed 1988 BMW E30 325i - Cirrus Blue Value

Thumbnail
gallery
147 Upvotes

Some high points:

Manual Transmission
Mileage - 108,277
Bought from Original Family (Mother’s car originally, eventually given to Adult Son)
Cirrus Blue with Gray interior
Interior excellent - Original crack free dash. Seats overall are good, but driver seat does have a tear on the bottom.
Garage kept - Condition reflects this
Underside has surface corrosion from NH driving, but any body or frame rust was previously taken care of by original owners.
Lots of money spent on maintenance. Approx. $15,000 spent within last 2,000 miles.
Past 2,000 Miles the following items have been done:

  1. Front struts and mounts

  2. Hood Strut

  3. Rear Muffler

  4. Rear Lower Control Arm Bushings

  5. 4-wheel alignment

  6. Floor board repair ($4,132.55) - Looks factory, very well done.

  7. Rear Window regulator

  8. Front wheel bearing

  9. Front rotors, pads, and remanufactured calipers.

  10. Remove and replaced front brake lines

  11. Brake fluid flush

  12. New Water pump

  13. New thermostat and housing

  14. New Timing belt

  15. New v-belts (all three)

  16. Valve adjustment

  17. O2 sensor

  18. New spark plugs and wires

  19. New distributor cap and rotor

  20. New engine coolant temperature switch

  21. New engine coolant temperature sensor

  22. Rear shocks

  23. New radiator shroud

  24. Replaced a few cracked hoses on top of engine

  25. Cleaned idle control valve

  26. Tires

What still needs to be done:

  1. Vibration at idle and sometimes while driving - Should replace engine and transmission mounts as well as guibo.

  2. Check engine light is on. I can’t get stomp test to give me code.

Overall, this car is a bit of a unicorn. Great color, garaged most of its life, manual transmission, maintained with an open checkbook, and owned by an enthusiast family. It looks amazing from 10’, but up close you can see road wear from almost 40 years and 108,000 miles of use. With that said, it’s a great car, and far better than most E30s I have seen that have been subject to multiple owners, deferred maintenance and neglect. Great bones for a full restoration, or a really nice driver for someone who appreciates a little patina on a mostly mechanically sorted car.

Looking for opinions on what $$$ I should start this at, and where would be the best place to list. I truly don’t know the E30 market well, and prices are all over the place between BaT, Facebook, and enthusiast forums.

By the way, I have all original manuals, bottle cap wheels and dealership info from the new sale (except window sticker). I also have a folder with service and parts receipts totaling $28k going back to 2010.


r/E30 • • 22h ago

Dropped a hex nut

Post image
4 Upvotes

Dropped a 10mm hex nut in this hole. I’ve seen other people mentioned they have to take the oil pan out.
I’ve already drained the oil, didn’t come out. Used a thin magnet but nothing. Any advice


r/E30 • • 1d ago

New noise after manual swap

5 Upvotes

Help diagnose new noise after I did a manual swap. Only make noise when rolling not at idle.


r/E30 • • 1d ago

Do I have a LSD? (91’ 318i m42)

61 Upvotes

Got new wheels today, decided to check out how they turned and discovered both wheels turn the same way when turning one of them. The car is a 91’ 318i with the M42


r/E30 • • 1d ago

Info needed Swift seat swap

Thumbnail
gallery
30 Upvotes

Gooday first time poster here I was wondering if anyone's mounted ZC31S recaros in there e30 before using the stock rails and might be able to offer some tips or tricks on what route they took and how they sit in the car I'm looking for something that'll be more comfortable on longer trips

Pfa my m52 swapped facelift


r/E30 • • 2d ago

Almost got the new door flush on my salvage title 318is

Thumbnail
gallery
27 Upvotes

DIY frame repair is not for the faint of heart. This car was only $3,300 and I like doing things for cheap. Given that it already has over 300K miles with a salvage title, there's no reason to pay someone to fix it.


r/E30 • • 1d ago

Info needed RPM Stutters under acceleration?

3 Upvotes

So I have a 1990 325iA and I just topped off the ATF due to a leak (Toptec 1200 mixed with at205 reseal) and now I noticed I have some rpm stutters under acceleration. Been leaking pretty significantly for 2mo before I could get to it, so it took about 1.25L

Any ideas as to what may be causing it? I believe the ATF is at the right level (hard to tell with the shitty dip stick) and I put everything to spec. The entire fuel system is new short of injectors but theyve never given me this issue prior, timing was done 2y ago and <10k miles ago, and valve lashings were done within 500 miles.

The car has always had a bit of a burbly idle since it got restored, but nothing severe. This is the first time where its stuttered under load


r/E30 • • 1d ago

Need to get some clamps for the intake for my m52b28. What’s a good size in mm? pcv to bottom intake boot not on/ shorties are barley connected to exhaust/ intake man air temp sensor to be replaced- hopefully all good after sensor and boot to pcv

Thumbnail gallery
4 Upvotes

r/E30 • • 1d ago

This keeps popping out.

Post image
5 Upvotes

What’s the best way to stop this popping out? I don’t think this part is listed on realoem. Glue it in?

I feel like I’ve seen various people leaving this disconnected and deleting it altogether.


r/E30 • • 2d ago

Might be a little out of my depth

Thumbnail
gallery
9 Upvotes

My rear drivers wheel arch and sill are totally gone and I need to cut them out and weld new metal in. However part of the rust is on the subframe mount and that’s where I’m jacked up on. What’s the best way to have the Car on jacks and also cut out all the rust in this corner?


r/E30 • • 2d ago

Price for a non running late model e30

2 Upvotes

Is 6k too much for a clean 1989 325i auto 2 door with a bad fuel pump?


r/E30 • • 2d ago

I'm making an E30/E34 reference site for parts and repairs. I need feedback from E30 owners

123 Upvotes

Hey everybody!

I've been building a reference site for E30s and E34s. It originally started with E34s, but I recently added a separate section dedicated entirely to E30s e34lore.com/e30 .

The site has an interactive 3D model that you can rotate, zoom in on, and take apart using an exploded view. You can click on individual components to find their corresponding BMW part numbers, OEM diagrams, and related service and repair information. You can also search for parts directly by number or browse the catalog to find what you're looking for.

There's also a part scanner that lets you take pictures of physical parts or upload existing photos to help identify them and find the corresponding information. I've been working on improving its accuracy, especially when it comes to identifying similar-looking parts and damaged parts.

I've added repair and maintenance information, factory manual references, wiring diagrams, fuse and relay information, and some troubleshooting guides as well. There's also a Garage where you can save your vehicles, keep track of repairs and modifications, and document your projects. I've been developing a Build Studio too, where you can experiment with different paint colors, wheels, interior options, and modifications, save your builds, and eventually share them with other owners.

Overall i want to make the 3D models as close to an accurate one-to-one representation of the actual vehicles as possible. I want to include the different engines, transmissions, trim packages, factory options, and eventually get into the finer details like brackets, fasteners, connectors, and individual mechanical components. I'm also working on making the models more realistic and making sure the parts and their locations correspond accurately to the actual vehicles.

I'm an E34 owner myself, so I don't have nearly as much firsthand experience with E30s. The E34 side is a lot further along at this point, and I'm trying to bring the E30 section up to the same level of quality and detail.

I've got a lot of ideas for additional features, but I really want to hear from people who actually own and work on these cars. Whether you're doing regular maintenance, restoring one, modifying it, or just trying to track down an obscure part, I'd like to know what would actually be useful to you.

I'd especially appreciate any feedback about inaccuracies, missing components, common problems, or things that could make the site easier to use. I'm still actively developing everything, and feedback from people who know these cars is one of the best ways for me to improve it.

The site is free to use, and you don't need an account to explore the models or technical references.

e34lore.com

You can switch between the E34 and E30 sections on the site. I'd really appreciate any suggestions or critiques. Thanks!


r/E30 • • 2d ago

Happy Friday the 13th 🔪

Post image
81 Upvotes

He asked for a pic


r/E30 • • 3d ago

Small Project Original Hartge Headers🤘🏼

Thumbnail
gallery
82 Upvotes

Always nice when people sell things about wich they have no clue what it is or what its worth.

Perfect addition to my next project: M20B26🤘🏼


r/E30 • • 2d ago

Need front sway bar bushing measurements

0 Upvotes

Hello everyone,

I have a 3d printer and printed bushings numerous times for my car, including rear sway bar bushings. I found a 20mm front sway bar model online but they absolutely don't fit.

I was wondering if one of you had a set of 20mm front sway bar bushings and would be willing to take some measurements for me, hole size, width, depth, distance between hole and top and bottom, etc.

I'd gladly share the print file for anyone wanting to print them using TPU once I test fit them.


r/E30 • • 1d ago

General Travis 🔩 on Instagram

Thumbnail instagram.com
0 Upvotes

Keep grinding in your builds!