had a motor with some issues, figured it would be easier to swap in anotherone i found on marketplace for a good deal, not a to good to be true deal though.
We swapped over pretty much all of our known good parts from the old engine to the new engine. as the engine had been sitting outside, and alot of those parts un known condition, we swapped over alot of the stuff. pretty much everything except the vp44 as i didnt have the tool to pull it.
we even swapped over our known good engine harness.
we plug everything in. it cranks fine. but no sputtering nothing. Ive swapped injectors, the liftpump is less than 2 years old. it runs for 25 seconds after a bump. Ive cracked lines and bled, everything seems to be fine but it just wont sputter.
I finally bought a fuel pressure kit, tapped it to the shrader valve at the fuel filter housing. reads practically nothing when cranking, and only about 7 psi after a bump on that 25 second cooldown period.
Ok, poor pressure to the vp 44. check all the fuel lines for any gaps or anything like that. its all solid ffrom what i can tell, and i get the same reading at the vp44 shrader valve too. i would be shocked if the lift pump went bad, as it was working just fine 2 weeks ago before we pulled the motor. But poor pressure, otherwise good fuel lines that i can tell, and correct high and low pressure lines are routed too and from the gas tank.
ive also checked witha multimeterthe voltage at the pump, it reads 12.3-12.7 volts so i know thats healthy. it drops to 8 volts after 30 seconds then shuts off. i think thats expected
so poor fuel pressure from the liftpump.
good fuel lines
good voltage
replace the pump right? Well, the new pump doesnt seem to run at all after a bump? if i move the line over to the old pump, it will fire right up, new pump doesnt.
is the new pump bad? or is the new pump telling me something is fucked up and the old pump just ran regardless?
im really really stuck right now. im considering swapping the engine harness incase maybe it got fucked up will i was installing the motor but everything i can tell is fine except for this fuel pressure issue. i have no idea how to proceed. ive swapped a new lift pump, doesnt run, ive checked all the lines. no dice. old lift pump runs, but low pressure. or is there pressure maybe leaking out somewhere? where are places i should be checking for this? no fuel is dripping or spraying out anywhere?