I wanted to share my solution to printer sound, temperature control, vibration management and all around neat build for my k1se.
It's not a secret that printers are loud, shake and shimmy like it's Saturday after payday, and can be fickle creatures. I contained that monster inside a box of lies, because I repurposed a "fully working" dishwasher I got for $10, into something actually useful.
Normally, I'd just fix any broken appliance I acquired, but in this case, the parts needed for repairing the heating element circuit wernt on hand, and ordering new parts cost more than getting a dishwasher I did have parts for.
So, I ripped out the pump, grinder, sprayer arms, as well as the top rack. Then, I snipped all the tines off of the bottom rack, as well as it's front end. This gave me a flat wire rack bottom, with an open front.
I cut a piece of scrap 1/4 plywood to fit snugly on the bottom of the wire rack, giving me a shelf on a pull out slide. I ran my electrical out of the side access from the upper sprayer inlet, and mounted an extractor fan on the bottom where the drain/grinder was. That fan is hooked up to the printer as a case fan, and would help extract fumes or regulate temp, if I needed it.
I mounted it on the top of 2 18" PA speaker cabinets that have seen much better days. While they work great, they look like they're out of the fallout universe. Those cabinets are attached to each other with some angle aluminum support struts from an old desk.
I use a cardboard shim to make sure the platform doesn't shake any, which it doesn't really, but better safe than crying over lost prints. I mounted a second camera in the top of the dishwasher looking directly down, and link that feed with the creality AI camera in fluidd.
When it's closed, it's almost silent, and keeps a steady temperature through the entire print. I can crank up the speed on my prints to 11, and not have the robot apocalypse sounds and shakes permeating my whole house.
I plan to add the CFS system to it, and either run the tube through the side where I pass the electric through (as it goes to a power line conditioner mounted in a custom filament drybox, with space on top) or I might mount it on top of the dishwasher enclosure, I just don't want to get the step stool out to swap filament.
I'm also aware the printer and enclosure aren't a pillar of pristine upkeep, the enclosure is in the back of my utility kitchen, and I just finished printing a custom telecaster body and haven't done a proper cleaning/maintenance mode yet.
But for anyone looking for a solution to the sound, vibration and environmental control for their printer, finding used and non functional dishwashers on FB marketplace can get you a cheap but top notch solution. Right now in my area there are 3 I could pick up for free because they don't work. They work just fine, just not for washing dishes.