Call it the wisdom of the crowd, but after reading the comments on my last Maxxum 7000 post, it did seem like a bad idea to go around knocking that copy around, taking it in and out of the cold, and possibly getting beer splashed on it at work. A thorough cleaning, internal battery replacement, and battery carriage swap were all that one needed, leaving me two cadavers on the desk. One destroyed body with perfect LCDs and some kind of fire hazard short inside, and one relatively clean body (grip is black and all there, but with two hairline cracks) with bleeding LCDs that wouldn’t rewind (after much digging around trying to find something wrong or jammed up in rewind end, and partial disassembly of the winder gears, I fixed this just by disassembling the battery compartment and cleaning the switches in the base plate… doh). Thus I set about swapping the LCDs, following the tireless documentation of Andreas Thaler. I relay my tale of woe here, mostly so this link is easier for future people to find. And maybe that rewind tip, since I didn’t see it anywhere else. Anyway, some notes and thoughts on the transplant process follow.
In the images attached, you won’t see the little cover that sits over this assembly (normally visible through the window in the top case). This is because it’s glued on, and made of metal just thick enough to not be called foil. My first attempt to remove it mangled the hell out of it, and while I was way more careful with the second one, I didn’t bother to replace it in this body. I had way bigger problems. Thankfully, it doesn’t seem to be functionally necessary, and this is after all my jalopy copy.
The viewfinder LCD ribbon cable is held in place by a spring clamp and a pressure bar. Upon removing these, you’ll notice the cable was glued exactly where it needed to be to line up with the connectors. Replacing it as is results in a blank screen. Get out the q-tips and the acetone, because ALL that glue needs to come off. Same with the pins on your ribbon cable. It’s especially stubborn on the edges. With all that clean, you can now swap the LCD assembly.
There are a total of seven tiny wires to desolder at the sides, and two screws in the front holding it down. With the clean ribbon cable and assembly now in your target body and clamped down, here comes the fun part. With no glue, there is a tiny amount of wiggle room in where that cable sits. Now you continually adjust that wiggle, and shims of electrical tape, until you get your entire viewfinder display back. With little to no rhyme or reason, tiny shifts in the shims or slight pressure on the case would cause enough pressure on the ribbon cable to garble or omit digits entirely. Thaler said this was a game of fractions of a millimeter, and I would shave that in half. Not to mention all this motion of the top cover meant resoldering various flash connections as they popped off the hot shoe or flex board. This being a flawed example anyway, I settled for “mostly legible” rather than perfect. Note the day to night transition. I’m never opening this camera again, lest I throw another nine hours at wiggling this connection and taking the top off and on, changing the order of the screws I tighten each time, since THAT inexplicably made a difference.
Originally intending to swap both the main and viewfinder LCDs, it says something for me to stop short and cut my losses on a camera. But, it’s something I never thought I’d tackle, and now I have a 7000 fit for high risk situations like… light drizzle. I will say, I have come to appreciate the thing, maybe more as an object than a tool for taking photographs. Regardless, I’m going to shoot it now out of pure spite. Maybe it’ll prolong the lifespan of my 8 other Maxxums. May it not ignite itself sitting on my shelf and destroy them. At the very least, I know the prism isn’t going to turn yellow. Long live Frankenstein, scars and all.