TLDR:
so every single guide on this ive seen has either given incorrect info or has left something out. ive seen a few people flaten to absurd amount like a millionth of an inch but not explain what they actually did i dont need to flaten to that degree but i do need to know the correct process that leads to that result.
also dont try to tell me i didnt do enough research ive put hundreds of hours into this and its only suppossed to take an afternoon at most.
SO
heres what ive gathered so far:
---make sure surface is flat. bought a granit surface plate flat to 0.000025 inches (four zeros after decimal)
---use the correct type of sand paper. silicon carbide sand paper (wet dry sand paper) seems to work and ive gotten part of something flat with it before
--- how to hold down the sand paper correctly? if the paper curls up at the ends then you wont be able to flaten. this is my most likely cause but not a single person that ive seen has said to make sure its held down. does the sand paper need to be held down OR is the sand paper dishing out and becoming bowl shaped?
---make the thing your trying to flaten hollowed not bellied. if it has a belly it will rock back and worth but a hollow will stop it from doing that
---proper technique??? some people have said to press down but for all i know that could just be to make the process go faster. lots of clearly false info floating around on technique that would be fine for wood workers but not for real flatness.
--- check whats going on using a sharpy marker bluing fluid etc.