Pedantic correction, but it's bending loads where you want material to be far from the neutral axis. For pure tension and compression, it doesn't really matter where the material is (although increasing the cross-section of your part will usually improve buckling performance).
In a shear loaded part, the highest stress actually occurs near the middle of the cross-section (from memory it's at the neutral axis but I might be wrong here).
Often, bending loads are what dominates so it still makes sense to put more material at the perimeters.
Sorry I meant tension and compression under bending, was slightly drunk, I avoid shear when designing my 3d printed parts. I’ll try to remodel an existing part that puts tension neutral to layer orientation.
13
u/insomniac-55 Feb 05 '20
Pedantic correction, but it's bending loads where you want material to be far from the neutral axis. For pure tension and compression, it doesn't really matter where the material is (although increasing the cross-section of your part will usually improve buckling performance).
In a shear loaded part, the highest stress actually occurs near the middle of the cross-section (from memory it's at the neutral axis but I might be wrong here).
Often, bending loads are what dominates so it still makes sense to put more material at the perimeters.