r/flying • u/PublicTailor4606 • 1d ago
Rectangular course vs traffic pattern
For rectangular course AFH figure, the turns begin at the end of the rectangular field boundary. Whereas the traffic pattern you dont turn until you are looking back at a 45 degree angle.
I know the rectangular course is replicating traffic pattern, and i want to maintain a constant distance, but should i just start the turn once at the edge of the field boundary, or should it be closer to a standard traffic pattern looking back at a 45?
2
u/ChartPuzzleheaded747 ATP CFI FW/RW 1d ago
It’s basically the same thing
If you turn at each 45 like the pattern jt makes a rectangle
Not sure I’ve had a student (or myself) ever asked to fly just that on a ride. Figure the traffic pattern checks the box for them
2
u/andrewrbat ATP A220 A320 E145 E175 CFI(I) MEI 9h ago
Yep 100% of my checkrides and student checkrides that required a rectangular course were done with traffic pattern
1
u/adnwilson Pylote 5h ago
I got asked to fly it on my Check ride. Threw me for a loop as we never actually practice it. But You fly one rectangle (Traffic pattern), you can fly them all! And as you said, it's 45 degree turns. Imagine a runway in the middle, make your box, on your "base" turn, go past your runway back to your starting point and go upwind.
*Edit* we did mine on a straight(ish) piece of coastline about 10 miles away from the actual airport.
1
u/iwonder___ CSEL CMEL CFI IR AP IA 1d ago
Doesnt really matter. You can/should do both. To fly a rectangle outside of a guide area is fine. To fly it along a guide area is also fine. Both have benefits to training.
1
u/ltcterry ATP CFIG 1d ago
Don’t make this complicated. Just fly a good pattern followed by a good landing.
1
u/Cri_Cri_Mike 1d ago
Rectangular course should be how the maneuver is outlined in the AFH. So abeam to the corner of the turn, not 45° out like in pattern.
1
u/tflyer 1d ago
Depends on who is testing/teaching. You may be told to fly a rectangular course around a section of road. From an instructor and an evaluator standpoint, my primary focus (other than obvious ACS standards) is to make sure you are perpendicular to the road when you cross it and parallel when on your "downwind" (your course, not your heading, necessarily), and that you are equidistant on both sides. That shows me you are effectively understanding and correcting for the wind. Where you turn might be part of that. Did I tell you to fly around it, fly within the field boundary, etc. But again, the intent of the maneuver is to show you can correct for wind, put the plane where you want it, and avoid other traffic while flying.
0
u/rFlyingTower 1d ago
This is a copy of the original post body for posterity:
For rectangular course AFH figure, the turns begin at the end of the rectangular field boundary. Whereas the traffic pattern you dont turn until you are looking back at a 45 degree angle.
I know the rectangular course is replicating traffic pattern, and i want to maintain a constant distance, but should i just start the turn once at the edge of the field boundary, or should it be closer to a standard traffic pattern looking back at a 45?
Please downvote this comment until it collapses.
Questions about this comment? Please see this wiki post before contacting the mods.
I am a bot, and this action was performed automatically. If you have any questions, please contact the mods of this subreddit.
9
u/Prof_Slappopotamus 1d ago
A rectangular course is turns around a point using straight legs in between every 90. It's only "like a traffic pattern" because it's a rectangle.