Every cave survey ends the same way. You’ve spent hours down there with the DistoX, every shot logged in TopoDroid, loops closing nicely. Then you climb out, muddy and happy, and the whole survey gets tied to the surface with… a phone GPS reading that jumps around by 8 metres because you’re standing under a limestone wall in a forest.
That one point is what places the whole survey on the map. If it’s off, the cave on the map is off too, and so is every comparison with the cave next door, with the dye-tracing results, or with the plateau above.
Proper GNSS gear fixes that, but nobody in a caving club is going to haul a €10k survey receiver up a muddy gully. So we built one ourselves.
OSS-RTK (Open Survey System) is an open-source RTK rover that costs roughly $80–140 in parts. It talks to your phone (SW Maps, QField, SurPad…), and with an RTK fix it gets about 1 cm horizontally and 5 cm vertically. The phone pulls corrections from a national CORS network over LTE, the same way the commercial kits do.
The catch for cavers: entrances love deep valleys without coverage. That’s what the optional LoRa bridge is for. You leave one small box on the ridge where there’s LTE. It relays the corrections over 433 MHz radio down to a second box at the entrance, which serves them to your phone over Wi‑Fi. The pair costs about $65–110.
Two honest limits:
RTK needs open sky. Right in a narrow shaft mouth or under an overhang, you’ll still need to set the point a few metres out and run a short survey leg to the entrance.
A local base station mode, for areas with no LTE anywhere, is still experimental and not implemented yet.
Everything is open: firmware, PCB files, BOMs and the 3D-printable enclosure. You can build it, fix it in the field, and adapt it.
We’re presenting a poster about it at EuroSpeleo Forum / Mundus Spelaeus 2026 in Pazin, Croatia (13–15 Nov). Come say hi if you’re there.
And the repo here: https://github.com/infrat/oss-rtk