I have a pair of wireless QuietComfort Headphones that decrease the volume semi-gradually without my input even after the reaching the bottom, which causes the headphone speakers to produce a repetitive “thump” noise
The audio quality itself sounds fine
I can use my phone’s volume buttons to adjust normally but it continues to decrease even with my input, I can “arm-wrestle” with it to keep it at a volume range, but if I hold down the increase-volume button to keep it at max volume, it will eventually trigger a “slingshot” affect where the volume drops to low or zero
It acts similarly when connected to my computer, including when paired individually
I borrowed a different pair of Bluetooth headphones and used them on both my computer and phone (individually and dual paired) and they worked fine, speakers and volume control on both devices also work fine when disconnected
There is no visual or tactile evidence of damage or debris with the headphones’ volume buttons, they don’t feel sticky or stiff when pressed, the acoustic click produced when pressed sounds normal, but pressing the buttons seem to no longer give responsive output to volume controls
Noise suppression still works normally
the auto-decrease problem only appears to happen when I have an app or webpage that plays audio open (i.e. music app, YouTube, etc.) so if it was purely a hardware issue I would assume it would be constantly lowering the volume but since it appears to only happen under those conditions, I suspect a firmware problem
I won’t rule out the possibility of water damage, I had worn them while walking in light rain but I had used them in similar conditions multiple times before with no affect on performance and the problem didn’t start happening until after I had been indoors for about 45 minutes
I checked the Bose app and all settings are on default
I checked my phone settings and I have nothing enabled that would auto-adjust the volume, and I have not installed any software that would do the same, I imagine if that was the root-cause it would also happen when Bluetooth is disconnected
I have tried individual pairing, forgetting the device, and charging to full battery multiple times to no avail
While writing this I found a half-fix by enabling Guided Access to “lock” the volume level, but with the caveat I need to do extra steps every time I want to change volume or exit the app, and I imagine it’s still draining the phone battery faster with the constant input signals from the headphone
Anyone have any advice on how to fix this or am I just better off going to a repair shop?
Thanks