Vevor Single Burner with stock gaugeless regulator. It seems like the flame is way too big. Maybe it's not?
But if it is, when I tried turning it down, it starts sputtering and then will flame backwards unless I turn it off and reset it via the leave everything before it goes into the forge. I reset it with a sense of urgency now because the first time it did this I didn't notice what was happening while trying to troubleshoot the sound, and I started smelling burning plastic from the warning sticker on the choke melting off.
I try to adjusting the choke open and closed. It seems like it'll burn from open to about halfway, so I'm using it right about half.
I reset the crappy regulator to zero, and then I crank it up about two full turns. If I go any lower it'll start sputtering after a few seconds. Sometimes after a minute.
Blue rhino tank is all the way on. I start it in this order.
Valve lever thingy at the end of the hose is off, regulator is closed completely, propane tank is closed completely. I slowly open the propane tank, then I turn the regulator about two turns, I like the forge with a piece of paper and then turn on the hose valve to open it up all the way.
I've tried starting the regulator with the hose valve already open, and with it closed. I have a conductive and insulating fire brick on the back to keep the flame from shooting out onto my shed wall, but I have tried it with the brakes completely removed from the front and back to maximize air flow.
Is it operating like it should according to the video? Do I indeed need to dial it back a little for standard forging after it heats up? Or have I missed a troubleshooting stuff before I try new tank or hose. The tank is full, I have another just like it that's also full.
Thanks in advance