r/bicycle • u/dirks74 • Sep 25 '26
PSA: Check the UDH washer on your new TIME frame
I bought a TIME NXR a few weeks ago and ran into a problem while building it. I’m sharing this so someone else might spot it before the same thing happens to them.
The UDH came pre-mounted on the frame. When I installed the rear derailleur, I noticed it was a bit loose, so I tightened the UDH nut. What I didn’t notice was that the washer between the nut and the frame was missing. As I tightened it, the head of the nut went into the dropout hole and cracked the dropout.
I contacted TIME and explained what happened. They said it couldn’t have left their factory like that because every frame goes through quality checks and is assembled and torqued to spec. I know I should have checked before tightening it, but the UDH was already mounted when I received the frame. I think the missing washer played a part too.
I asked whether they would sell me a replacement frame at a 50% discount. They declined. TIME also has a crash replacement program with 40% off the regular retail price, but they wouldn’t offer that because this wasn’t a crash. Their only offer was to repair the frame for €500 plus shipping. I sent it in for repair, and when I later asked whether they could at least give me a discount on a new seatpost, I didn’t get a reply.
At the time, there was no NXR assembly manual included either, just a QR code linking to the manual for the older ADH. I couldn’t find any instructions for the UDH setup.
The whole experience has taken the excitement out of the bike for me. Whatever you think about who’s responsible, please check that the washer is there before you tighten the UDH on your new frame.