r/askaplumber • • 8h ago

Leaking water storage tank

Thumbnail
gallery
369 Upvotes

Any thoughts on best options to repair a leaking 2500 gallon water storage tank (stores my well water). Tank is roughly 7 years old. Located in Southern California. Looking for serious advice, not “Flexiseal” jokes.

Edit: For everyone saying to use Flex Seal, do yourself a favor and read the fine print. The manufacturer states to not use Flex Seal products that come into contact with drinking water for humans and animals.

Fine for screen door boats, not drinking water.


r/askaplumber • • 12h ago

How does this look?

Post image
162 Upvotes

Replaced s-trap with p-trap and Studor AAV. Flushing toilet no longer causes tub drain to gurgle.


r/askaplumber • • 5h ago

Any feedback?

Post image
25 Upvotes

Had our water line go out in the middle of the woods on a long run. There's a slight elevation difference (1/2"?) between the inlet and outlet. I ended up slapping a swing joint on and it seems to be working well.

Should I backfill if this holds for a week or is there a better way to address this?

For context, the previous owners ran this up against a large stone. A root worked its way in between and the pressure against a coupler caused it to pop in half.

Bonus question, what should I backfill with? I'm thinking sand with a layer of top, but I'm not certain what would be best.


r/askaplumber • • 5h ago

Was is this on the faucet?

Post image
12 Upvotes

I’ve seen this pinned bar on faucets from time to time. What is its purpose? Thanks!


r/askaplumber • • 2h ago

So I fkd up... any ideas on what I missed?

4 Upvotes

Doing a a cartridge changed on the posi valve moen 1222 so fix a leaky spout but after hours of trying to rip the original one out im stuck with this with the new one any ideas why?


r/askaplumber • • 4h ago

I'm having issues flushing my toilet. Any suggestions on fixes.

5 Upvotes

I've been having issues flushing my toilet for the past few days. Any suggestions on solutions to fix it?

I flush the toilet, the water rises (much higher than it typically should) and takes a while to drain.


r/askaplumber • • 8h ago

Water leak

9 Upvotes

Hello. This is in my attic and difficult to reach. I believe I may have to open the wall/ ceiling to access it which is fine. What would you all recommend to fix it?


r/askaplumber • • 4h ago

Replacing overflow drain. Will this work?

Thumbnail
gallery
2 Upvotes

I want to replace the overflow drain of my bathtub without being too invasive. The solution I’m thinking to try is unscrewing the nut and removing the top part of the current drain, and then replacing it with a kit I bought from Lowe’s, cutting it down to size. Does this seem like a feasible solution, or am I setting myself up for introducing water damage/is this not viable to begin with?

(NB: we have to replace it because we’ve been unable to get the rusted out screw that’s stuck on the face of the overflow plate)


r/askaplumber • • 8h ago

Water heater slowly dripping from white discharge pipe — bad relief valve or something else?

Thumbnail
gallery
4 Upvotes

I noticed water slowly dripping from the bottom of the white pipe running down the side of my gas water heater. It’s not a steady stream, just one drop at a time, but it’s enough to leave a puddle on the basement floor.

The water heater was manufactured in 2022, so it’s relatively new. From what I’ve read, this appears to be the discharge pipe for the temperature and pressure (T&P) relief valve.

Any advice would be appreciated. I’d prefer to troubleshoot it myself before paying for a plumber, assuming it’s safe to do so.


r/askaplumber • • 4h ago

Problem Replacing Shower Cartridge - Help Appreciated!

2 Upvotes

I'm redoing my shower and decided to replace the valve cartridge since it has been dripping after showers. My home builder originally used one that didn't have any name or anything but I found delta that fit snug (O-ring instead of Clip).

The issue is when I turn the main water on, the shower head blasts water. Tried everything I can think of including having the knob turned off when installing. Any type of feedback or help would be much appreciated - got a wife and three kids that want to shower lol. Thanks all.


r/askaplumber • • 15h ago

Rate this Copper Work

Post image
13 Upvotes

Professional commercial plumbing for pressurized highly flammable gas.


r/askaplumber • • 1h ago

Tankless Water Heater Tripping Only When One Bath Runs

1 Upvotes

I have a Norris gas tankless water heater that trips a code 90 “turbulent combustion”, but only when one bath is running. Does trip on any other bath or when the shower is running. Can run a shower and sinks with no problem. This same bath also makes a pretty distinct sound when running almost like a creaking, wailing hiss that is absent from the other bath. Can’t take a bath in this tub without it tripping every few minutes. Definitely worse in the winter as the input water temp drops. Does this one bath somehow have a higher flow than the other bath and the heater can’t keep up? Does it sound like the water flow is weird and causing a chain reaction? Just looking for some input. Had a plumber look at it several months ago and he didn’t find anything wrong. I flushed it a couple months ago and inspected the intake/outtake and they seemed to be clean. Unit was clean inside. The expansion tank on the output side does appear to be expired. Thanks!


r/askaplumber • • 1h ago

Anode rod replacement frequency for residential tank water heaters?

1 Upvotes

How often should homeowners realistically inspect or replace the sacrificial anode rod in a standard glass-lined water heater? Is it better to check it every 3 to 5 years depending on local water hardness, or wait until signs of premature tank corrosion start showing up?


r/askaplumber • • 1h ago

Put electrical outlets above or below utility sink beside washer or behind?

1 Upvotes

I'm adding a washer dryer stacked combo. Very little space. Immediately to the left is a wall. To the right is a deep utility sink. I need both 120 and 240 outlets for them. I could put receptacles above the sink, below the free standing sink, or directly behind the washer and dryer. They are ventless and only require 2" of clearance in the back but I could give more. Electricians are silent.

What do you suggest?


r/askaplumber • • 2h ago

Tap cartridge issue

1 Upvotes

The hot tap was leaking when the cold tap was turned on. I removed the cartridge, cleaned it, lubed it, and reassembled the tap. The leak has stopped (yay!), and the tap turns as before, but now the hot water does not turn off.
What did I do wrong?


r/askaplumber • • 2h ago

Boiler Pressure Relief Valve Leaking

1 Upvotes

Hi all, I have a boiler pressure relief valve leaking, looking for some advice for what the culprit could be.

It is a tankless boiler, recently installed in 2022, so all components are about 3 years old aside from radiators and pipes.

-My relief valve is leaking about 2 gallons per hour with cold water. I replaced the relief valve with a brand new one, still leaks. It could be a bad valve, but I want to check other things as well before replacing it again.

-Water pressure seems to be about 20psi with cold incoming water.

-Expansion tank is good (not full of water), air pressure is about 10-12 psi

-Reducing valve seems to be working properly. It is a Taco valve with a little handle on it that can turn about 30 degrees or so. Pressing down on the handle allows more pressure which activates the pressure relief valve.

-Only other matainence I did was to clean the magnetic iron filter.

Please let me know what you all think the problem could be, or if I just replaced a bad valve with a newer bad valve.

Last thing I need to add is that the valve to feed the pressure reducing valve is open. Please let me know if it should be off if the system is full of water or if it should remain on. I am unsure and wouldn't be surprised if I just need to shit it. Thanks!


r/askaplumber • • 13h ago

Shower fixture broken same way twice

Thumbnail
gallery
7 Upvotes

I had this connecter break on the hot water side of the shower fixture after a few months of use. Obviously made a made a mess before I could shut it off. Replaced the connector as I assumed it was just a bad piece. Well the same piece broke in the same manner again after about 6 months of use. What would be the cause and how can I fix this permanently?


r/askaplumber • • 3h ago

Does these new anode rod look correctly installed?

Post image
1 Upvotes

I have a American Water heater. I removed the old sacrificial rod and installed this new corrotec powered titanium rod. Does this appear correct?. I feel like it sits a little high.


r/askaplumber • • 4h ago

Removing collet from in line water cannister

Post image
1 Upvotes

I’m currently working implementing a new in line water filter under my sink. Currently Im trying to remove this collet from the cannister to start over since I think I implemented it wrong but I’m having trouble removing this brass callet. Its one of those adjustable push ins. This is a whirlpool in line refrigerator filter (WPINL30) that produces 2500 gallons.

When I tested this, there was some droplets dripping out of the brass tabs towards my in line which I’m trying to troubleshoot right now.

Any tips?


r/askaplumber • • 4h ago

Low pressure in fridge

Thumbnail
gallery
1 Upvotes

I had this water filter on my fridge water line. Don't know how long it was there but anyway, it sprung a leak and the other pictures are the ends I was left with to put together to fix the problem. I did not want to replace the filter. So we fit the copper and that other tube together with some sort of compression fitting and now the pressure of the water coming out of the fridge is terribly low. Any idea where I went wrong?


r/askaplumber • • 4h ago

Insulation for hydronic heat pipes in attic?

1 Upvotes

We have hydronic lines going up from the basement, through the attic, and then back down into our 2nd floor. The pipes are exposed in the attic, and we're headed into winter months in the northeast US.

It seems weird that a heat pipe would be at risk of freezing but if they go off while the house is warm, it's a risk right? Should be insulated?

Not sure what I should use to insulate them. Someone recommended the 'pool noodles' insulation but I'm reading online that it may not be good and could melt?


r/askaplumber • • 5h ago

How can I take off this Lever Assembly

Post image
1 Upvotes

The nut turns but there is no progress.


r/askaplumber • • 5h ago

Will this work? Copper elbow has internal threads currently hooked up to a 1/8” x 1/4” compression valve. I’m hoping the threads on the elbow are fip.

Thumbnail
gallery
1 Upvotes

r/askaplumber • • 9h ago

Do plumbers scope vents?

2 Upvotes

Toilet on lowest floor gurgles when washer upstairs has a light load on delicate cycle. Everything drains well, so I suspect a vent issue.
2016 new build home, sole owner.