r/Watches • u/DotField • 2h ago
Discussion PSA: How to kill a $1k military watch with the corner of a piece of paper
I learned a hard lesson a few months back and figured I should share so you don't have to. I'd had my Marathon SSNAV, a pretty tough watch by any measure, for about a year and a half. This is the quartz version, so very little can go wrong. Unless, maybe, you're an idiot.
I was setting the time one day and noticed that the threads of the screw-down crown had gotten a little gunky. So I took the corner of a piece of paper that was to hand and used it ream out the threads, pausing occasionally to blow the little clots of sticky junk off. Soon enough it was clean and I screwed the crown back down, very pleased with myself.
The next day I noticed the time was off by five minutes. I thought maybe I'd mis-set it before, so I reset it. The watch ran for a few minutes, then stopped, this time for good. Battery change didn't help.
My theory is that some shreds of the junk I scraped out of the threads fell down into the movement and gummed up a gear. It could probably happen with a mechanical watch, too, but a quartz analog movement would be particularly vulnerable because of the tiny amount of torque the stepper motor generates compared to the force of a mainspring.
It *might* just be random bad luck, but I think the early failure rate for a simple mid-grade ETA quartz movement must be vanishingly low. So, be aware.