r/TEAMEVGA • u/Intoxicus5 • Dec 27 '20
PSA: Do NOT use Daisy Chains for 3000 series!!!
I've been looking at the specs for Molex Mini Fit Jr 5556 and using daisy chains for 300 series is questionable at best.
Spec chart from Molex Mini Fit Jr 5556 spec sheet: https://imgur.com/a/tJGJXys
At best it's rated for 9 amps, but more likely 8 amps because it depends on wire gauge and materials used.
The highest rating is 9 amp at 16 gauge. There's also a 9 amp 18 gauge on the chart.
At 9 amps * 12 watts we get 108 watts. Then it's actually rated per pin so that's * 3 for the 3 x 12 v pins in the connector's housing. We get 324W.
At 8 amps it's 288W across 3 pins. But that can also be on 16 gauge depending on materials used.
The PCI-E spec says 150W. The ATX spec doesn't seem to mention daisy chains at all. Leaving it up to what molex recommends for the Mini Fit Jr specs. Which according to Buildzoid almost no one uses 16 gauge for daisy chains like they're supposed to.
That's quite discrepancy between 288W from Molex and 150 W from PCI-E...
And then factor in inefficiency. You're not getting the full 288W in the first place because nothing is 100% efficient. That loss in efficiency results in heat.
What benefit does anyone get from using a daisy chain anyway? There's no reason to say a daisy chain is better. There are reasons to be concerned a daisy chain is detrimental.
In the case of the the post that got me on this the thought process is that if a daisy chain is supposed to be able to do the job of two cables then why does Nvidia say hard no and it caused at least one magic smoke?
If a daisy chain can do the job of two cables then shouldn't it be fine to use with an FE? Of which Nvidia specifically states to NOT use daisy chains with the FE cards...
It would seem so far that a daisy can NOT reliably do what two cables can do as we're being told by some.
And if it can not reliably do what two cables can do why is anyone telling to use daisy chain power cables in place of separate cables?
It would seem it's something from before 2000 series and 3000 series that was fine until power draw got serious like it is now. And instead of revaluating if they're still a good idea people are thinking they're still acceptable to use.
Personally before my current EVGA 3080 FTW3 Ultra I had a 2070 I initially powered with a single daisy chain cable. I had to go to two separate cables because of crashing and instability. As soon as I realized my error(how can one cable do the work of 2 cables) and went to a proper configuration everything worked fine. That was a plain 2070, no overclock at that time, on a 1000W EVGA Supernova G3 Gold. By the math it should have had enough watts. A 2070 draws 215W roughly. With an estimated 288W per connector we should have been good there. Unless the cable can't handle the draw even though the connectors can...
That Seasonic chart? At best it only applies to Seasonic PSUs. At worst it's garbage and should be retracted.
I've asked EVGA Jacob and/or other EVGA techs to please explain their logic behind their bad advice on this topic on the EVGA forums.It seems like they should know better than that. I really want to know why they think it's ok to use daisy chains at all when the evidence seems to say otherwise.


