I'm looking for some second opinions.
I have an RX-8 with a 13B-MSP Renesis that supposedly has approximately 20,000 miles on a remanufactured block.
I didn't get paperwork or compression test oh well sue me 😔. $8,000 got me a clean 60,000 miles chassis car with supposedly 8,000 miles on the block. it now has 76,000 chassis and ~20k miles on the supposedly second engine
The car actually drove and drives great. Pulls strongly at higher RPM, and idles smoothly, but I've been having some issues.
The tester showed approximately 291 RPM (brand new battery), and I recorded the ALT readings.
Front rotor: - Chamber 1: 6.3, 5.9, 5.6 bar
Chamber 2: 6.2, 6.0, 5.7 bar
Chamber 3: 6.0, 5.7, 5.9 bar
Average: 5.92 bar
Rear rotor: - Chamber 1: 5.9, 5.7, 5.5 bar
Chamber 2: 5.8, 5.7, 5.7 bar
Chamber 3: 5.8, 5.7, 5.8 bar - Average: 5.73 bar
My understanding is that Mazda's factory minimum is approximately 6.8 bar corrected to 250 RPM, which would put both rotors below specification.
The engine takes longer than normal to start, both hot and cold. It gradually catches, then idles normally......I believe this to be ignition related, didn't start doing this, and the sluggish starts till bhr coils...
- It has some sluggishness under low-RPM load, particularly pulling away in first gear.
- It comes alive at higher RPM and otherwise drives surprisingly well.
- I previously experienced a P0301 misfire under load.
- I traced that misfire to a BHR ignition coil issue through substitution testing. With OEM coils installed on both front-rotor positions, the misfire disappeared. The rear still has BHR coils. I'm currently waiting on a replacement set. I don't have the other 2 OEM coils
Do these compression numbers indicate that a rebuild is necessary, assuming the ALT readings are correctly calibrated to 250 RPM?
Is it possible it can still drive as well as it does with those readings?