r/RX7 • u/Suitable_Handle2910 • 11d ago
Compression test thoughts?
Thinking about buying this 87 t2 with 84,000 miles he sent these compression tests what do y'all think?
1
u/Spirited-Pace-2373 11d ago
Run
0
u/Suitable_Handle2910 11d ago
Seriously I figured 120 compression is good?
4
u/_pcakes 1987 11d ago
each rotor has 3 compression faces. This style of test is made for piston engines, and on a rotary it will show only the best compression of each rotor. For example you could have 1 corner or face of your rotor that totally makes no compression, and this test wouldn't show it
2
u/Suitable_Handle2910 11d ago
Fuck I didn't even think of that. What if it cold and hot starts fine? He said he's comfortable getting a compression test if I'm there. Which is was thinking of doing anyway
4
4
u/MaybeGod88 11d ago
There are compression testers for rotarys
1
u/DB3rt11 11d ago
I would personally love to know where cuz i tried buying one from rotorycompressiontester.com and they are sold out🤷♂️
3
u/evileagle 1988 10AE TII - REW Swap, 1993 R1 11d ago
I use the one from Rotarytronics.
https://rotarytronics.com/product/rotary-compression-tester/
2
u/The_Giant_Twitch 11d ago
The only thing you can check with this tester is to see if the 3 chambers have roughly equal conpression spikes. Then you know they are prob okay ish. You cant measure realistic compression of a rotary with it.
2
0
11d ago
[deleted]
5
u/Suitable_Handle2910 11d ago
So not really useful?
5
u/WhereDidAllTheSnowGo 11d ago
It’s better than a 10 psi reading
That tells you the max of all three. The other two could be zero


13
u/djseto 11d ago
If you're going to use a piston engine tester to test compression, there is a trick that you can use that works: You must remove the schrader valve so that way, when the compression tester reads, it doesn't hold the previous value. Remove the Schrader valve and then run a compression test by cranking the motor. I like to use a cell phone camera with a high frame rate so that way you can play it in slow motion and watch the pulses of each one. If you don't remove the shrader valve, then the first pulse will hold in place and not release the needle to go back down for the next compression reading. Its not the same as a proper rotary tester but people did this all the time before non oem rotary testers were available to the masses.
Here is a write up
https://www.banzai-racing.com/compression_test.htm