r/RTLSDR • • 5h ago

What are these helical energy blocks i keep seeing on waterfalls?

Thumbnail
gallery
16 Upvotes

i have sighted them many times, but never took screenshots.


r/RTLSDR • • 11h ago

Some cool 40 M SSTV receives 11/1526

Thumbnail gallery
6 Upvotes

RTL SDR V4, SDROxide and Balun 50' Dipole


r/RTLSDR • • 12h ago

Second Meteor M2-4 capture after 5 months! 85.6° max elevation pass from an RF-quiet country house while friends were barbecuing :D

Thumbnail gallery
7 Upvotes

r/RTLSDR • • 10h ago

Elektro L3 with diy equipment

Thumbnail gallery
4 Upvotes

r/RTLSDR • • 1d ago

A new driver for the Radioberry 2.x - corvus-radioberry

Post image
5 Upvotes

r/RTLSDR • • 1d ago

Another try to decode radiosonde frames

4 Upvotes

A few days ago, I posted a video of a potential RS41 signal; apparently, the sound was disabled. This time, here is a different video.

Heard this signal when a balloon passes within the range of 40km from my location.

Is this a RS41 signal?

Edit: Video with sound


r/RTLSDR • • 1d ago

RTL-SDR not working fine in Raspberry Pi 5 but working so fine in my laptop

4 Upvotes

Why do I get better images using my laptop than using the raspberry pi? There are so many black lines in the pics, though it improved when I used a usb extension.

I am frustrated with it because my data collection should be automated using the raspberry pi.

I get good imagery with my laptop even without the usb extension.


r/RTLSDR • • 2d ago

The Cheap SDR is Disappearing

108 Upvotes

r/RTLSDR • • 2d ago

Struggling with dipole antenna

12 Upvotes

So, I have my rtl-sdr USB plugged into my Linux box and I have a diploe antenna attached to it, I can pick up airplane information, but I am really struggling to pick up any satellite information. I do see data downloads, 1 to 2 gb of data, but none of it decodes and when the ISS passes overhead I get nothing but static. Is there a better antenna? I've been watching YT and I'm looking at a new GOES antenna that I'm going to order. Just looking for some general directions. Thanks


r/RTLSDR • • 2d ago

[REVIEW REQUEST] SDR (50kHz-14Mhz) - FST3253 as MIXER - LM4562 OP-AMP

Thumbnail
gallery
9 Upvotes

SDR based on Dan Tayloe Quadrature Product Detector made from analog switch FST3253.

Principle of operation:

  • We demodulate signal with FST3253 analog switch.

  • Clock signal for mixing is generated by Si5351 module located on seperate pcb, soldered by header pins.

  • Si5351 also generates clock for PCM1808 ADC.

  • Demodulated signal from mixer is buffered and put into LM4562 for amplification

  • Then amplified signal is sampled by PCM1808 ADC, data is transfered to rp2040 for further digital processing.


Q1: Should i split ground for digital and analog parts?

Q2: Can the clock traces go under the U7 op-amp output traces? Will noise emited by clk lines drown the signal ?

Any suggestions / comments about footprint placement, routing are welcomed.


r/RTLSDR • • 2d ago

I made yet another rtl_power csv to image heatmap generator that's minimal but pretty fast

Thumbnail
github.com
1 Upvotes

r/RTLSDR • • 2d ago

Changed setting?

1 Upvotes

Good afternoon, I'd like to start off saying I'm very new. I recently purchased the nooelec rtl-sdr v5. I struggled to get any signal for a while then after I purchased a cheap antenna for 2m/70cm I managed to get the weather radio and 2 local signals I could listen to. Today I got adventurous and started looking around the lsb to see if I could pickup anything. Well I ended up giving up on that and went back to the signals I knew I could listen to. Now the local signals are are all static, I can hear / see them micing up but I only hear static.

I imagine I messed with the wrong setting somewhere but I have no clue where or what.

Any pointers to where I should start to get those signals back clear?

I've tried various software but I'm currently using HDSDR but I'm getting the same results on SDR++ and SDR#


r/RTLSDR • • 2d ago

Greetings , I have this clone version of deep sdr 101, with Geehy chipset. I need anyone who has it, to do a backup of its firmware and send it to me. the procedure is very simple and can be done online via this DFU mode:https://devanlai.github.io/webdfu/dfu-util/

Thumbnail gallery
0 Upvotes

r/RTLSDR • • 3d ago

Multi PSK will be free starting in January

19 Upvotes

Author posted this in French over on facebook, found the English announcement. http://f6cte.free.fr/Licence_En.htm


r/RTLSDR • • 3d ago

Software I built a free browser player for public KiwiSDRs, with a night-side map and a "what's strong right now" scan. Feedback welcome

Thumbnail
reddit.com
1 Upvotes

r/RTLSDR • • 3d ago

Sharing our P201Pro industrial-grade SDR — Zynq 7020 + AD9361, field-deployable

8 Upvotes

Most of us here know the drill: RTL-SDR + Pi + dump1090 + Flightaware feed. It works, but you're juggling four components.

We just released the P201Pro — a Zynq 7020 + AD9361 SDR board that runs the whole stack on-board. It boots Linux from SD, runs dump1090 natively, and pushes ADS-B data out the Gigabit Ethernet port directly. No host PC, no separate Pi.

Specs relevant to ADS-B:

  • 1090MHz reception (obviously), 56MHz real-time bandwidth

  • On-board GPS module for position/time sync

  • -40~+85°C temp range, 8–36V input — designed to sit in an outdoor enclosure

  • 1GB DDR3 (no more Pi memory bottleneck when you're feeding multiple services)

It's a step up from the typical RTL-SDR setup if you're building a permanent monitoring station rather than a hobbyist feed.

Questions welcome.


r/RTLSDR • • 3d ago

Antennas It's easy to build an simple dipole without an connector for the antenna?

6 Upvotes

I unfortunately have these blue dongles and it's connector is an MCX, for now I can't buy an adapter for SMA.

My question is if it's possible to connect a DIY antenna to the SDR through an very well placed copper wire wire on the MCX connector. I personally don't want any soldering on the SDR.

Or maybe I can use the standard monopole's base (the leg can be easily unscrewed form the magnet base) and put an larger DIY leg on it, this way I can use the connector normally.

Any help on that?


r/RTLSDR • • 4d ago

Raspberry Pi AIS station to get me every ship in the world

Thumbnail
gallery
41 Upvotes

Had some issues with a side project of mine and I'm at a loss. This is new to me, so bare with me.

Backstory first. I setup a NooElec NESDR Smart on a Pi 5, in a box with a couple of fans, wired up to a whip strapped to the chimney. AIS-catcher runs in Docker and sends everything to AISHub over UDP. It's been up since August and has decoded about 1.2 million messages, around 13,000 a day, mostly the same few boats repeating themselves every few seconds. I live inland, so my AIS station on the roof hears 10 to 20 boats a day.

This setup allowed me to get positions of a much larger sample of ships from AISHub - if you share your feed with them and they give you their global feed back. It has been running since August fairly consistency, but I got knocked out in September due to a power outage. I didn't want to loose my feed so I got the Pi back up on a 12 V battery with a smart charger (for when the power came back), through a Yahboom PD Power Expansion Board (the Pi 5 one on Amazon). The station went nearly deaf, from hundreds of messages an hour to about 7 a day, for five days. The shore base station nearby still came through fine every time, so the antenna was OK. A spectrum sweep looked clean too, because switching noise comes in bursts and averaging hides them, and an AIS burst is only 27 ms long. Once I was able to get power back and I connected it back on the wall supply, it recovered within minutes. I tried diagnosing and the best I have is it's the Yahboom board or the battery wiring. Still haven't figured out which. Haven't lost the power since, so I haven't played with it since.

Has anyone else had similar issues with that Yahboom board or any another buck converter and have it wreck their AIS reception? Is there a supply you'd trust for running one of these off a battery?


r/RTLSDR • • 4d ago

Antennas 24 Hours of Galactic Hydrogen using the Disc Yagi and an 8 bit RTL

Post image
48 Upvotes

r/RTLSDR • • 4d ago

Lake Erie ship tracking with SDROxide and built in AIS

Post image
4 Upvotes

r/RTLSDR • • 3d ago

Software Onair, software that decodes literraly everything that exists

Thumbnail
reddit.com
0 Upvotes

r/RTLSDR • • 4d ago

DIY Projects/questions Raspberry pi scanner?

Thumbnail reddit.com
1 Upvotes

r/RTLSDR • • 3d ago

I’m new to amateur satellites, so I built Vessel: a free, open-source macOS app that tracks, receives and decodes satellites in one window

Post image
0 Upvotes

Hi everyone,

I got into amateur satellites recently and found a lot of great tools along the way: Gpredict for tracking, SDR++ for receiving, SatDump for decoding, AMSAT and SatNOGS for data. As a beginner, though, I kept juggling three or four programs and copying frequencies between them.

I’ve been programming for 17 years, so I built the app I wanted as a newcomer. Vessel brings tracking, receiving and decoding together in one native macOS app with a friendly interface.

What it does

  • Tracking: a 3D globe with 17,000+ satellites, a sky radar that draws the locked satellite’s path, pass predictions, countdowns and a lock history

  • Receiving: detects your SDR automatically (tested with RTL-SDR and Airspy), then tunes, follows the Doppler shift and decodes, with a live spectrum. No SDR? You can listen through public SpyServer stations.

  • Decoding: weather images, SSTV, packet and telemetry, using SatDump as the built-in engine

  • Transmitting: for licensed operators only, through public amateur uplinks, with safety checks

Status: this is version 1, so expect rough edges. The prebuilt release needs an Apple silicon Mac with macOS 27.2 or later. On older macOS you can build it from source.

Looking for contributors and feedback. I’d love bug reports, ideas, feature requests, and especially reports from people with other SDRs (HackRF, SDRplay, LimeSDR, PlutoSDR and others). Code contributions are very welcome too.

GitHub and download: https://github.com/afterplanet/Vessel

Huge thanks to the SatDump, SDR++, Gpredict, AMSAT, SatNOGS and CelesTrak communities. Vessel wouldn’t exist without their work.


r/RTLSDR • • 5d ago

Testing the SDRplay RSP1B with a physical FM Filter & internal RF Notch (Quick comparison)

Thumbnail gallery
7 Upvotes