r/PatternDrafting • • 2d ago

Help rising the crotch

I’m doing these asymmetric jeans and just realized the crotch is way too low but with all the unconventional patterns I don’t wanna mess it up, any suggestions to fix this? I will send the patterns to the community once finished 🫵🫂

9 Upvotes

6 comments sorted by

4

u/Far-Number4325 2d ago

Don't slash into those asymmetric seams to move the crotch point around. Add rise with a straight horizontal spread so the unusual lines stay put.

The 3D already shows the waist sitting pretty low and the fork hanging off the body, so this is short rise, not a crotch curve that needs more scooping. Scooping the curve will make it cut in and won't lift it. In the 2D window, draw a line across the front and back, roughly between the hip and the crotch, perpendicular to the grain. Cut and spread the same amount on every piece that makes up the rise, including both sides of the asymmetric design. Start with about 1 to 1.5 cm, true the side seams and inseams, and resimulate before you go bigger. Use the measure tool from the body's crotch to the garment so you're not guessing.

The important part with an unconventional pattern is seam length. After the spread, the left and right pieces still have to match at every seam, and pocket bags, yokes, fly, and belt loops have to move with the rise. If one panel is short and the other isn't, the twist you designed will get worse, not better. Don't just drag the crotch point up in 3D and call it done, that usually distorts the thigh and the inseam and doesn't transfer cleanly back to the pattern.

If the waist is also a bit loose, the whole thing will keep dropping even after you add rise, so check the waist and hip ease while the waistband is pinned at the height you actually want. And toile it in a similar-weight denim or at least a firm woven before you cut the real fabric. A low crotch in CLO is cheap to fix. Recutting fashion fabric isn't.

1

u/Krispy_flowerboi21 2d ago

Thanks for the response. So I ended up doing 2 horizontal 2cm width darts in both fronts and backs, then I rose the rise 2 more cms both front and backs, somehow I still have some extrafabric down there, I Will test is on a real model and see what extra fixes are needed, thank you all for your comments

2

u/RitalinLover 2d ago

What software is this?

1

u/JEG- 2d ago

old version of clo3D

2

u/TensionSmension 2d ago

You're getting good answers. The real issue is you can't design pants if the waist isn't stable. First decide exactly where you want the waist to sit and either attach to a waist tape drawn at that level or freeze the waistband.

6

u/ladygrift 2d ago

Videos are the only media type allowed on mobile (at least for me) so here you go. Measure down from where you want the crotch, and raise it on your pattern. The rise will look really short, but the pant is drapey and low rise so that’s fine.