r/OpenPV • • Dec 11 '14

Finding a switch NSFW

I have been looking to build an unregulated box mod twin 18650's in parallel. Though I will probably never use the full potental of 60 Amps I would like to get a swtich that can handle the most possable current. I have already looked at doing a mosfet design and I would rather not do that, I would much rather just do wiring.

My preference would be amazon or somewhere that I could get it fairly commenly wether it be a radioshack or something of the like.

Thanks in advance for all the help!

1 Upvotes

9 comments sorted by

5

u/thrwbak Dec 11 '14

Doing a mosfet is doing wiring. Spend the 3 bucks and buy one and do some wiring.

Your not gonna find a switch that will do what you want to do. Your not gonna find help here for what you are looking for.

You wanna build a mosfet box? I can help.

4

u/david4500 Dec 11 '14

http://i.imgur.com/bUdCZBX.png

skip radioshack & amazon. get parts from mouser or digikey.

2

u/silent_erection Dec 11 '14

you're not going to find a switch that you like that will handle 50+ amps. Most of the switches that say 60 amps on ebay are lying are most likely rated for 10 amps at the most. Like everyone else has said, just use a mosfet and never worry about it again. http://imgur.com/1yuBZwD <This is what a TRUE 50 amp switch looks like. got it from a local electronics store. this switch by itself has half an ohm resistance. A mosfet has 23 MILLIohms of resistance which means that much more voltage gets sent to the atty instead of a handwarmer of a switch

2

u/toxictaru Dec 11 '14

There is a reason why MOSFET boxes are recommended here so often: there are no particularly good and acceptable switches to handle the amp load. Adding a MOSFET is trivially easy, and skipping it for just a switch is foolish.

1

u/goooooooofy Dec 11 '14

You can do a mechanical switch i actually posted a pic of how i did one a few days ago

1

u/silent_erection Dec 11 '14

mechanical is a myth. if it passes electrons then its electronic. the concept is nice but you never know what those "mech" switches are rated for because nobody has done any tests. mosfets are rated for hundreds of thousands of cycles without failure

1

u/goooooooofy Dec 13 '14

1

u/tehbilly Dec 13 '14

Contact surface area and oxidation are my primary reasons for not liking these. Nothing quite as fun as performing maintenance on a contact point to keep performance from degrading.