r/Kseries • u/BigBuddyBruh69 • 13h ago
AEM Analog to KproV4
I have been chasing this issue for a few weeks now to get my closed loop running properly in low load. Here's the situation and symptoms
Vehicle: 2003 Civic Si (matching ecu on kpro)
New AEM 30-0300 gauge and new FAE sensor
Wiring:
-red wire to switched 12v on add a circuit (tried mirror motor, acc radio, etc, all same symptoms)
-black wire to G101 ground
-white wire to Kpro internal AN0 pin (tried AN1 and 2, same symptoms)
-brown wire to Analog internal ground (also tried pin A10 on ecu, same symptoms)
Symptoms:
-typically reads fine after a cold start, will remain that way indefinitely until I turn off the car and restart
-reading usually gets more accurate and smooths out when I put more load on the engine (more throttle and map)
-occasionally the noise will clear up and then immediately return
For basically any given configuration of wiring it'll still exhibit all 3 of these symptoms. I even tried buying a new gauge and it still persisted. I just want closed loop 😩. Any help is greatly appreciated.