r/Hummer • u/metapulp • 20h ago
H2 Air suspension small leak
Anyone recommend an aftermarket brand? Small leak on driver side only.
r/Hummer • u/metapulp • 20h ago
Anyone recommend an aftermarket brand? Small leak on driver side only.
r/Hummer • u/No-Basis-6663 • 16h ago
Hey y’all,
Potential new H3T 5 owner here. I was driving down the road and passed an H3T a few times. Finally decided to pull over and take a look. The truck is super clean and appears to have been really well taken care of. It has 160k miles, and the owner is asking $12k.
I’m not too familiar with these trucks, but I’ve always thought they would make a fun weekend vehicle to cruise around town in.
I’m coming to you all for some advice. Am I looking at a potential money pit, or could this actually be a worthwhile purchase for someone looking for a fun weekend truck?
What should I be looking out for mechanically, and is $12k reasonable for one with 160k miles?
r/Hummer • u/NeuralFlow • 7d ago
r/Hummer • u/Longjumping-Pin-9193 • 7d ago
r/Hummer • u/az_auto_aesthetics • 9d ago
Big EVs make paint correction and maintenance a different kind of job. We recently worked on a 2026 Hummer EV in Mesa and paired paint correction with FEYNLAB Ceramic Ultra V2, then added XPEL XR Prime Plus ceramic film on the windshield.
The correction was there to refine the factory finish and bring up the clarity and gloss before the coating went on. On a vehicle with this much bodywork, the coating’s practical upside is maintenance: its slick, hydrophobic surface helps reduce dirt buildup and makes routine washing easier. It is not chip armor, and the owner still needs to rinse dust away before washing and dry the vehicle properly, especially in Arizona where water can dry quickly on hot panels.
The windshield film was a useful complement because the Hummer has such a large glass area. The goal was to help reject heat and cut glare without changing the basic experience of sitting behind that broad windshield. I like that this package addressed both the finish and day-to-day comfort rather than treating “protection” as one product.
For anyone with a large EV or SUV: do you find ceramic coating meaningfully changes how long it takes to wash and dry the vehicle, or is the main benefit the easier cleanup afterward?
https://wedetailaz.com/2026-gmc-hummer-ev-mesa-az-paint-correction-ceramic-coating-windshield-tint/
r/Hummer • u/TheBehemoth01 • 9d ago
So I bought my dream truck yesterday afternoon. It’s an 07 with 140k miles. I knew the lines were rusted but they weren’t the worst I’ve seen. I was driving it the 8 hours home and lost all breaking power. Thank goodness I didn’t have a catastrophic event happen but I was able to pull off the highway and into a gas station. Come to find out I have a pin hole in my break line. I just bought JEGGS fitted brake lines. I’ve seen some videos on replacing the lines. It seems like a total pain in the butt. I do have a lift I can use. What are your experiences with this and do you have any tips. TIA
r/Hummer • u/JR_Franklin • 13d ago
Hey guys,
I'm having this noise in the hood and it has progressively gotten worse over a year. I know audio is a but different on video, but here's a video of the noise. The thump at the end is unrelated.
It seems to be the driver side. I was thinking maybe The Harmonic Balancer, but that's a fairly wild guess paired with some AI Assistance.
If anyone has had a similar experience, please let me know. I have a 3 hour drive in 9 days so I need to fix this ASAP! 🙏
r/Hummer • u/ThatHcGuy24 • 16d ago
r/Hummer • u/Background-Slip8744 • 16d ago
2006/07 (gmt800 style) 6.0l lq4 4l80. Just pulled a standard cab 1995 ford f150 from northern Illinois down to southern South Carolina and was not happy with how high my trans temps were getting. Had to run it in 3rd to keep them under 200. My other problem was well 9 mpg is what I signed up for and no regrets I love driving this beast but the 25 gallon fuel tank is not enough for a trip like this and I would love to continue making this trip in the hummer. So please any recommendations for what worked well for you guys for either of these issues would be awesome thank you.
r/Hummer • u/Curious_Injury_333 • 17d ago
Just had my window replaced (2010 H3) and was told I needed to start getting clips together. Is there a source for bags of these?
r/Hummer • u/TheFixer2019 • 19d ago
Recently replaced the water pump, engine coolant sensor, secondary air valve, and thermostat and housing. Needless to say, the system was completely evacuated and therefore a ton of air in it. I know have coolant behind the engine side of the thermostat, coolant filled on the radiator side of the thermostat, radiator is filled, suction hose to reservoir and reservoir have coolant.
I filled the internal engine coolant passages between the radiator and the outlet side the beat I could by removing the hose from the radiator top side and pouring coolant in through the hose.
In my mind the air that could still be trapped in the system should be minimal, but I keep experimenting a temp gauge that goes to about 1/8 above cold and holds and then drops to cold and the dreaded AC Off message pops up.
I've tried to burp the system using the radiator cap off method, the lifting the front end method, and now the coolant system pressure test/fill kit method with the venturi assembly. The message still keeps coming up on the dash. When I used the vacuum method, I got the vacuum down to 20 inHg with the compressor connected and running and the lever open on the vacuum assembly. When I closed the compressor lever, it dropped to 10 or so. When I open the coolant line to allow the vacuum to draw coolant in, I have been able to get it to draw in 1/2 gallon before vacuum returns to normal. I like in Denver so high altitude and thin air.
Help please! I feel like I'm likely missing something simple or that there's a method that I haven't come across that will finish this and get rid of that AC Off message once and for all.
Thank you in advance for the expertise and direction!
r/Hummer • u/West-Trash4073 • 21d ago
2006 Hummer H2. I've changed plenty of headlights but have never seen one like this. What is the second bulb? I bought 9007 replacement bulbs but they won't fit into whatever this is. How do I replace my headlight??
r/Hummer • u/ItsStxcks • 21d ago
My 2007 hummer h3 runs fine until u been driving for about an hour and a half then my check engine starts blinking and it acts like it was to stall out but don’t when I pull over and turn it off then back on it starts running fine need some help the mechanics can’t even figure out what’s wrong with it
r/Hummer • u/novaking_07 • 21d ago
23.5” lift on this junker. Center cap to bottom of fender
r/Hummer • u/jwood61111 • 21d ago
Looking for a 2005 H2 Headliner. Anyone have one that's in decent shape?
Thanks,
Woody
r/Hummer • u/GOBL1NS1ayer • 21d ago
I have a 2010 Hummer H3 3.7 5L, the factory radiator is busted. It has bad leaks at the seams where the plastic meets the aluminum. Currently trying to look for an upgraded replacement, maybe one that’s full aluminum. But not sure witch brand to go with. Any recommendations?
r/Hummer • u/EstablishmentMost359 • 22d ago
Update: replaced the battery after initially thinking it was just a battery issue because the original battery was tested and was determined broken.
Car won’t start. Occasionally it will turn over but then die within 5 seconds. Weird clicking and rumbling noise heard around the engine and under the driver side. Won’t start in neutral either (suggested in previous post). Any ideas? Thank you
r/Hummer • u/Dark300z • 28d ago
This is my first hummer. I read how impractical they are. Wawawa. This one is the 6.6 LBZ Duramax diesel with the Allison 6 speed transmission a 2003. It gets 18 to 20 miles per gallon. and it has 179,000 miles on it. I love it.