r/DIYUK • u/conken84 • 12m ago
Any tips on how to best fill this hole?
Annoying hole in the floor of the hot press that I’d like to fill or black in some way. Talk me out of just bashing a load of expanding foam down there
r/DIYUK • u/conken84 • 12m ago
Annoying hole in the floor of the hot press that I’d like to fill or black in some way. Talk me out of just bashing a load of expanding foam down there
r/DIYUK • u/MediumBuffalo92 • 14m ago
Stupidly attempted tiling yesterday and it didn’t look right. Removing it today and the paint underneath has obviously come away with the adhesive.
Will this need skimming again or can i just use filler on the whole area?
r/DIYUK • u/False-Crow9198 • 14m ago
Hello,
We bought a Victorian property and we're slowly working through one nightmare after another.
I just stripped the wallpaper in the bathroom, removed the skirting board and saw that there are two deep holes in the walls in each corner at floor level.
Very drafty.
Can somebody pls the me what the heck is going on?
😅
All advice much appreciated.
r/DIYUK • u/ChillAndroidMk7 • 15m ago
Struggling with replacing this corroded radiator valve to get this heating again. Couldn't get the little ring off the pipe to get the new valve to attach so had to accept defeat and put the old one back on to stop it leaking everywhere.
Anybody got any thoughts on how to do this? Is the ring/washer thing soldered on here. Anyone who's done this would be great to know how hard it was!
r/DIYUK • u/AnonNightK • 21m ago
Hi everyone.
We've recently purchased a property (~10 years old) with a balcony roof. The balcony is on the first floor and sits above the downstairs bedrooms.
The balcony had rubber mats which I've since pulled up as I knew there would be moss to clean. The images show the balcony without those mats and before cleaning after a couple of days of heavy rain.
The survey of the property was excellent and no issues were raised there about the structural integrity of the balcony or roofing in general. There is no evidence of damage, leaks, etc, though a better inspection will be done once I've cleaned.
I've a few questions:
- how best should we clean/maintain the balcony? I know I should avoid using anything abrasive or jet washing. But should I use particular cleaners or tools?
- both images show some pooling towards the end of the balcony. We have had two days of heavy rain, and the images are taken early in the morning before the sun has come out. The area closest to the house looks to be OK, but the pooling is a bit of a concern.
There is drainage in the centre and on the left of the balcony which appears to be working well, but it's clear it's not totally effective. How best can I prevent the pooling? Are we looking at needing work to recover the balcony to better direct the water? Or better drainage? Or is the pooling nothing to be too concerned about?
I'd appreciate any help or advice. Thanks!
r/DIYUK • u/thehooperlooper • 23m ago
Wife bought an expensive outside lamp for above our front door. She's very particular and put a lot of time into selecting this specific one....
We were having the front wall re-rendered but I gave the builder the wrong measurement for the light fitting. Now the hole's too large 🤦♂️
I haven't told my wife yet, but I know it's too late to return the light so I need to try to fix this before breaking the bad news...
Options?
- Fill the hole with more sand cement render and smooth off as best as possible? It'll all be painted over in Spring anyway...
- Mount the light above it, drill track to get the electrical cable up, then patch existing holes with sand cement?
- The light fittings can mount directly on a metal circular junction box which is sitting inside the wall... If I somehow extend the depth of the round metal conduit box to bring it closer to the render surface, then patch around it?
Please help me out of trouble here 😅
r/DIYUK • u/Lower-Anywhere-792 • 23m ago
Went out and bought some HG mold spray and a FFP3 mask just to come back to my accomodation to see maintenance had fixed it ! No idea how though. However they have removed the acute problem but did absolutely nothing about the extractor fan. It's not extracting any of the water vapour or hot air. I know this after i tested with a piece of toilet roll, it had no suction. I placed a vacuum to the fan to see if there was any dust that had clogged it however none came out.
I did mention about the extractor fan not working to the maintaince team however they seem to have brushed it off. I’m afraid this problem is likely to come back given a month's time. Any suggestions for what action I could take ?
r/DIYUK • u/johnnysalad • 25m ago
Not sure how to finish this off ? Caulk and paint with wall colour, or some oak wood filler?
r/DIYUK • u/Adorable_Chemistry92 • 31m ago
Hi all - looking for some advice regarding a suspected damp issue in my toilet. Ground floor mid terrace maisonette.
Noticed some paint coming off the wall, after buying a moisture reader it appears I’ve got some damp in the wall.
For context this is a separate toilet (not bathroom) and this wall backs on to neighbours wall. I thought it was a solid wall onto the next terrace but now thinking it must be an outside wall. Only discovered this properly last night so haven’t been able to get round to neighbours yet.
As a note, toilet does not have a window, has an extractor but not working since we’ve moved in (Feb this year). So there is a lack of airflow too.
The picture attached is after I’ve stripped some of the paint which was bubbling and peeling.
The next wall along from the toilet is a small landing in between kitchen which has a radiator a foot away from the toilet door. The wall around the radiator does not seem to have any issues and is not showing high readings.
The wall is only measuring as high on the moisture reader at the bottom of the wall, and appears fine towards middle and top.
As that’s the case I think it may be a damp issue from neighbours flat / outside wall rather than a slow leak. But of course I could be wrong hence asking the Reddit community.
Any advice appreciated!
r/DIYUK • u/Dibbsters • 33m ago
Got a very noisy whistling radiator here when the heating is on. Seems to be coming from all over not just one specific place i.e. the lock shield valve or TRV.
It was taken off and put back on in the summer to decorate. I’ve since tried bleeding it and water came out straight away.
Anything else I can try or is it just the nature of this type of radiator?
r/DIYUK • u/voice_noter • 48m ago
Hi, moving into a property and the previous tenant has glued their carpets down. There's still chunks of glue down carpet, I'm trying to scrape it up but some of it is really, any recommendations on what to use to get it removed.
Thanks
r/DIYUK • u/Opening-Strategy-236 • 1h ago
Hi,
I have to remove this electric fireplace and I can only see 2 brackets behind holding the centre part of the marble.
No issue taking off the electric part and wires but the actual marble seems solid. Is it fair to assume they are holding with extra strong glue or am I missing something (like it's all in one piece ) ?
What would be your recommendation ?
Many thanks
r/DIYUK • u/BoxClassic5039 • 1h ago
Sadly I don't have a tape measure. This is a generic smartwatch nothing fancy like apple. I know what charger I need but What mm charger do I need for this?
r/DIYUK • u/Ok-Highlight-4085 • 1h ago
Hello,
I have a single leaf garage which is freezing in winter. The main culprit is the garage door (old up and over with gaps so big it might as well not be there).
I'm thinking to replace the door at some point and add a bit of insulation. It will be a workshop/laundry area so doesn't need state of the art insulation.
I like the tall cealing and was wondering if I could add plasterboard and maybe insulation while keeping the vault?
I guess I can't just screw plasterboard to the rafters with insulation between them?
r/DIYUK • u/HelloMishMoneypenny • 1h ago
Paint UPVC - primer and top coat or multisurface
Looking to paint internal window frame from rosewood/brown to white.
Got the prep sorted but not sure if it would be better long-term to use Bedec Multi Surface paint, or a primer of Zinsser 123 and Zinsser Allcoat for finishing.
The Bedec paint has good reviews and obviously the application is easier as you only need one product and Zinsser 123 looks a bit tricky to apply flat without noticeable brush strokes.
Although even if it uses more products and takes a bit more patience, I don't mind using the primer and topcoat if it is a better solution. Just don't want to try a simpler method then regret it.
r/DIYUK • u/Competitive_Pause_62 • 1h ago
Google lens tells me it's improperly wired is that the case ?
r/DIYUK • u/Some_Tumbleweed_27 • 1h ago
r/DIYUK • u/yesandnobutmaybe2 • 1h ago
I've been stripping wallpaper in the front room of my Victorian terrace and I found a note from 1929, looks like it was from the decorator, maybe. Anyway, I had a tea break and imagined what life must have been like back then... they didn't know who Hitler was, they had open fires, the used lead in their paints... So it dawned on me that I'm probably scraping layers of lead paint... Am I?
I ordered a test kit and left the room and closed the door but how does everyone else do it? How do you strip the wallpaper without giving yourself a lead poisoning? If the paint underneath the wallpaper does have lead, should I continue stripping the wallpaper but wear a PPE? What's the course of action here?
r/DIYUK • u/Shepherdson-00 • 1h ago
Does anyone have a suggestions on what to use to paint roller blind.
Im decorating my son’s nursery and the roller blind in that room is fairly new so feels like it would be a waist to buy a new one however, its pink with flowers all over it. So I thought about painting it to match with the room however, I am at a complete loss on what is best to use to paint it. If anyone has any suggestions I would be grateful
Thanks in advance ☺️x
r/DIYUK • u/WasteofMotion • 1h ago
Hi all,
We are having new carpets fitted throughout (You don't realise how much shit you have until told to clear it all!!)
On the landing I have a squeaking floorboard or two - high rate of travel - top of stairs between master bedroom and bathroom - so very well trodden.
Given the opportunity I would like to sort out the squeak between them lifting the carpet and laying a new one, what is the best way of going about this ?
Nails, screws or something else - perhaps something under them, if of course I can make the boards even again (big if, I am guessing!)
Thank for your time reading this!
(Also anything else I could do given this once in a decade or more opportunity?)
r/DIYUK • u/WasteofMotion • 1h ago
Hi all,
I have a bunch of spurs wired into wall mounted electric radiators - would I be ok the change them to a normal socket, so that I can add a thermostatically controlled intermediate between the power and a radiator ?
cheers, wom
r/DIYUK • u/Respond_Sometimes • 2h ago
I am in the middle of insulating between the joists of my suspended timber. Some of the bitumen DPM has cracked and where I have been lying on the ground the cracking is worse.
Should i look to top up the bitumen in these areas , add a new dpm on top or just wait and see what happens?
As per title really. Bought some bin stores which I’ll doctor a little to make work in our scenario. My key question is what is the best way to fix them down?
Tends to be quite windy around us (primary reason for bin store is to stop them blowing over in winter) and so I’ve opted for ones which are slatted so I don’t put up a big sail basically.
Is it sufficient to just drill into a block? Alternatively I’ve thought about removing blocks at the fixing points & pouring some small concrete footings to keep them down, but feels like this might be over engineering it.
Thoughts/ideas/suggestions very much welcome!