r/Cisco • • 21h ago

Question A stackwise virtual question

I finished a catalyst 9407 stackwise virtual upgrade firmware recently, show redundancy print chassis 1 is active, chassis two is standby hot, I noticed the chassis 1 interfaces config , like , GigabitEthernet 1/1/0/1, the config not sync to GigabitEthernet 2/1/0/1, I need copy the entire 1/x/0/y to 2/x/0/y (management card slot 3 and 4 not include) to make the network stable.

I know stackwise virtual will sync the config from active to standby , but I am not sure why interfaces config not sync, or, I need to configure two chassis separately?

3 Upvotes

7 comments sorted by

4

u/Pellopolus 21h ago

You have to configure all the ports separately. The global config is synced. Even the ports are synced in the config but it’s expanded basically how a 9300 stack is expanded. Chassis 1 is the active and if it goes down chassis 2 takes over with the same config.

2

u/Sogetsuchang 21h ago

Oh , I see, I will discuss with my mates, because the guy who sold and build it told us the interfaces will sync, and I confused between Cisco documents and his words, thank you!

1

u/Whole_Hand862 18h ago

It’s common to build port channels, bonding multiple interfaces. Using the same port on both chassis makes it simpler. There are additional concerns and requirements when setting these up.

Some things like trunk configuration are applied to the port channel interface and replicated to the members.

This may be what your vendor meant but did not adequately describe.

7

u/cronhoolio 21h ago

It's treated as a stack, not a mirror. You have to mirror the config manually across the chassis. Best way to do this is ether/port channels across both chassis. If that's not supported by your hosts then you need far more education than reddit can provide.

Edit: ether not either.

1

u/bigboss-2016 12h ago

What's been your experience with StackWise tech from these 9407s? A while back we had one chassis freaking out and unfortunately chassis 2 couldn't take full control because chassis 1 still tried to maintain control. Resiliency and confidence died that day.

1

u/mohammad_abusaa 10h ago

The DAD details check out against Cisco’s SVL troubleshooting doc (216537). It says Dual-Active Detection (DAD) and SVL configuration must be performed manually and the devices must be rebooted for configuration changes to take effect, and its sample config shows interface GigabitEthernet2/5/0/43 stackwise-virtual dual-active-detection. show stackwise-virtual dual-active-detection is suggested in a Cisco Community thread on 9400 ePAgP DAD, and the ePAgP form uses dual-active detection pagp with trust channel-group under stackwise-virtual.

1

u/mohammad_abusaa 10h ago

That sounds like dual-active, where both chassis think they’re the active one. Dual-active detection is meant to catch that, either with a dedicated DAD link (stackwise-virtual dual-active-detection on an interface) or with ePAgP through a port-channel to a downstream switch. It isn’t there unless you configure it, and changing it needs a reload, so plan a window. Worth running show stackwise-virtual dual-active-detection on any SVL pair.