r/BambuLab • • 1d ago

General Troubleshooting/Help! Please Help!

Post image
0 Upvotes

10 comments sorted by

2

u/FakeFrik 1d ago

Which filament are you using? The air around your print might be too cold for the material you are trying to use.

2

u/ZenSlicer9 1d ago

Its from the cold, make sure it's warm in the room and there are no open windows

0

u/[deleted] 1d ago

[removed] — view removed comment

1

u/ZenSlicer9 1d ago

In that case next is adhesion, either clean your plate or put some glue stick before printing

1

u/sapani9077 1d ago

Poor bed adhesion due to dirty build plate

-2

u/[deleted] 1d ago

[removed] — view removed comment

1

u/Orvess 1d ago

Clean it ?

1

u/Odd-Place780 1d ago

This just happened to me for the first time.

I did a few prints and didnt wash my plate before the issue happened. Its a bed adhesion issue most likely. Wash your plate with dawn blue soap and hot water.

The corner lifted off the plate. Sucks man